JVC HM-DT100U E Start playback, B Load a cassette, F Start recording, A Make connections, D Set recording speed, C Select input location on this VCR, Input Source

EN 81

A Make connectionsAConnection with the camcorder

Connect a DV cable between the camcorder’s DV connector and your VCR’s [i.LINK] connector.

BConnection with the VCR

Connect an i.LINK cable between the playback VCR’s i.LINK input/output connector and the recording VCR’s [i.LINK IN/OUT] connector.

NOTES:

•Depending on the devices equipped with the i.LINK connector which is connected to the VCR, picture noise on this VCR may differ from the noise on the connected devices. It is caused by the difference of the data processing method.

•Connection with certain product(s) may not be supported. (A ‘ATTENTION’ on the back cover.)

B Load a cassette

Insert the cassette to be recorded on into this VCR (for recording).

E Start playback

Press [PLAY (I)] on the connected device.

NOTE:

If the connected device is equipped with a superimpose/ OSD disable feature then set it to “OFF” before starting playback.

F Start recording

On the front panel:

Press [REC (R)].

On the Remote:

Press [REC (R)] and [PLAY (I)] at the same time.

NOTE:

If “108 REC BY HS MODE” appears on the TV screen, refer to ‘Error Codes and Messages’ on page 92.

Do not connect this VCR to the PC with the i.LINK cable. The operation is not guaranteed.

C Select input location on this VCR

On the front panel:

Press [CHANNEL +/–] to select “I-1” etc.

On the Remote:

Press [TV/VCR CH +/–] to select “I-1” etc.

•When “I-1” is selected, either the front or the rear i.LINK connector can be used, the VCR will automatically switch to the appropriate connector being used.

D Set recording speed

Press [REC SPEED] to set the recording speed.

•For more details, refer to ‘About Recording Speed’ below.

About Recording Speed

		Input Source	Selectable Recording Speed
	(Playback device)		(Recording device: This VCR)
i.LINK/ DV		D-VHS	Auto (HS/STD)*, HS, STD, LS3
		DV-camcorder	HS, STD, LS3
input
		Digital Set Top Box (Others)	Auto (HS/STD)*, HS

*Auto mode : The recording speed will be selected automatically according to the amount of data input (the transfer rate) from the i.LINK connector.

NOTES:

• When dubbing using the i.LINK connector, set the recording speed on the recording VCR to the same speed as the source tape on the playback VCR.

• When Auto is selected for the recording speed, “AUT” and the selected speed appear on the front display panel in turn.