64 EN
INFORMATION ON J TERMINAL
J Terminal (JLIP(Joint Level
Interface Protocol) Connector)
The J Terminal is used to connect the VCR to a personal
computer or similar device to allow computerized control of the
VCR during editing and certain other operations.
For further details consult your nearest JVC dealer.
U.S. customers can contact JVC directly toll free at 1-800-252-
5722.
JLIP ID Number
Your VCR has its own JLIP ID number. This ID number must be
unique when your VCR is connected to another device via its J
terminal. The ID Number is preset to "1" at the factory. You can
change this number to any number between "1" and "99".
If it is necessary to change the JLIP ID number perform the
following steps.
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS INITIAL SET
SCREEN
2
Move the highlight bar (arrow) to "INITIAL SET" by
pressing CH 5∞ or TIME SCAN %fi, then press OK or
TIME SCAN .
ACCESS JLIP ID NO. SET
SCREEN
3
Move the highlight bar (arrow) to "JLIP ID NO. SET" by
pressing CH 5∞ or TIME SCAN %fi, then press OK or
TIME SCAN .
SET JLIP ID NUMBER
4
Press NUMBER key to
enter the desired ID
number, then press OK.
RETURN TO NORMAL
SCREEN
5
Press MENU.
NOTE:
This VCR may not accept a command from your personal
computer such as:
●
Power ON/OFF while the VCR is in the Timer mode.
%%
JLIP ID NO. SET
1
PRESS NUMBER KEY (O-9)
THEN (OK)
PRESS (MENU) TO END
123
456
789
0
2
4
1
3
JOG
SHATTLE
+
−
OK
MENU
MENU
OK
TIME SCAN
CH
NUMBER
(MONO)
IN OUT
AUDIO
VIDEO
CH3
CH4
ANTENNA IN
TV OUT
CABLE
BOX
IN OUT
S VIDEO
L
R
AV
COMPULINK
REMOTE
PAUSE VHF/UHF
J terminal
Back of VCR