To assemble and connect the AM loop antenna

To assemble the AM loop antenna

To connect the AM loop antenna cord

1 Hold

3 Release

2 Insert

•If the AM loop antenna wire or speaker cords are covered with vinyl, remove the vinyl to expose the tip of the antenna by twisting the vinyl.

•Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. Also, keep the antennas away from metallic parts of the System, connecting cords, and the AC power cord. This could cause poor condition.

To connect the speaker cords

1 Hold

3 Release

2 Insert

Speaker

Speaker

cords

cords

(black/blue)

(black/blue)

 

Speaker cords

 

(black/red)

From right speaker

From left speaker

•When connecting the speaker cords, match the polarity of the speaker terminals: (+) to (+) and (–) to (–).

•Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

•The speakers are magnetically shielded to avoid color distortions on TVs. However, if not installed properly, it may cause color distortions. So, pay attention to the following when installing the speakers.

–When placing the speakers near a TV set, turn off the TV’s main power switch or unplug it before installing

the speakers.

Then wait at least 30 minutes before turning on the TV’s main power switch again.

Some TVs may still be affected even though you have followed the above. If this happens, move the speakers away from the TV.

•DO NOT connect more than one speaker to each terminal.

•DO NOT push or pull the speakers as this will damage the foot spacers at the bottom of the speakers.

6