Illustration is LT-46E910

How to attach the stand

NOTE:

•Unplug the AC cord from the AC outlet.

•Ensure that unpacking and transfer of the unit is carried out by two or more people.

•Before beginning this process, assure that TV is laid on a clean, safe, and cushioned space to avoid any damage to the unit.

•Do not touch or press the TV-screen, glass might break under pressure.

Place the TV on its front onto a table.

Align the stand’s bottom-plate (supplied) as seen here.

It will fit in only one direction.

Hold the unit and attach the stand slowly, as shown in Figure 1.

LCD PANEL SIDE

Figure 1

Illustration is LT-42E910

Figure 2

Finally secure the bottom-plate with 4 screws (supplied) as indicated by the arrows in Figure 2.

• Be sure to follow the instructions. Insufficient tightening or incorrect installation of the stand will not support your unit correctly, and could result in damage or injury from tip-over.

How to remove the stand

When you transport this product, remove the stand and pack flat against the back of the unit in the carton. To remove the stand, perform these steps in reverse order.

For wall mounting, the base must be removed. To disconnect the base/stand remove the 4 screws from the back.

Notes when mounting the LCD TV on a wall

 

 

• If the unit is to be mounted on the wall, contact the retailer where you purchased the LCD TV for advice, and have the

equipment professionally installed. Incomplete or improper installation may cause injury to you, and/or damage to the LCD

TV.

 

 

 

• Bracket holes: To attach a wall mounting bracket (not supplied) remove the screw, then attach where indicated in the

drawing right.

 

 

 

• This manufacturer recommends professional installation.

 

 

• Utilize an appropriate bracket and fasteners, sufficient to accommodate the size and weight of the unit.

 

• Assure the wall to which the unit is to be mounted will safely support the size and weight of the unit, using the bracket and

fasteners you have selected.

 

 

 

• Keep cords and cables connected to this flat panel display out of reach of children.

 

 

• To hang the television on a wall, remove these screws and then remove a stand. Before performing work spread cushioning

over the base area to lay the TV on.

M6 × 10

400mm

M8 × 15

 

200mm

 

 

 

Bracket holes

 

Bracket holes

400mm

200mm

 

 

6

Screws

Illustration is LT-42E910

Screws