JVC RX-80PGD - page 24

Page 21

English

Using Preset Tuning

Once a station is assigned to a channel number, the station can be quickly tuned. You can preset up to 40

stations at random.

To store the preset stations

On the front panel only:

1. Tune in the station you want to preset (see above).

If you want to store the FM reception mode for this station, select the FM reception mode you want.

See page 22 for details.

2. Press MEMORY (next to the TUNER button).

“CH-” appears and the channel number position starts flashing on the display for about 5 seconds.

3. Press Control % / ﬁ to select a channel number while the channel number position is flashing.

• Pressing Control % increases the number.

• Pressing Control ﬁ decreases the number.

Note:

You can use the 10 keys on the remote control to select the preset number. When using the 10 keys, be sure

that they are activated for tuner, not for the CD and others. (See page 44.)

4. Press MEMORY (next the TUNER button) again while the selected channel number is flashing

on the display.

The selected channel number stops flashing.

The station is assigned to the selected channel number.

5. Repeat steps 1 to 4 until you store all the stations you want.

To cancel a stored preset station

Storing a new station on a used number erases the previously stored one.

CAUTION:

Preset stations may be erased when power is cut off to the receiver, as when it is unplugged

from the AC outlet or a power failure occurs. If the preset stations are lost, simply set the stations

again.

To tune in a preset station

On the front panel:

1. Press TUNER so that the Control % / ﬁ / @ / # buttons work for tuner settings.

The lamp next to the button lights up.

2. Press Control % / ﬁ until “–PRESET+” appears on the display.

3. Press Control @ / # to select a preset channel.

Each time you press the button, the preset channels changes.

• Pressing Control @ changes preset channels in decreasing order.

• Pressing Control # changes preset channels in increasing order.