20
English
Creating Realistic Sound Fields
B.SEARCH
REW FF
F.SEARCH
ENTER
VOLUME
VCR CHANNEL
TUNING
DVD FM/AM AUX MUTING
123
456
789
0
REMAIN
PROGRAM
D.R.C
SETUP
SLEEP
EFFECT
DSP MODE
TEST
PRO LOGIC
SETTING
SOUND
CLEAR
REPEAT
ANGLE
SLOW
SEARCH
A-B REPEAT
ZOOM
2 3
PRO LOGIC
SOUND
D.R.C
Adjusting Stereo Sound
You can adjust the following settings.
It is recommended that you make adjustments from your actual
listening point while listening to reproduced sounds.
–Output balance for the front speakers
–Output level for the subwoofer
Once you adjust these items, the adjustments take effect for all the
surround modes.
Before you start, remember...
•There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
2
again.
1
Select and play any source except Dolby Digital
or DTS Digital Surround.
2
Cancel Dolby Surround or DSP modes if they are
activated.
For deactivating Dolby Surround:
Press PRO LOGIC on the remote control until
“STEREO” appears on the display.
For deactivating DSP modes:
Press DSP MODE (or DSP on the front panel)
until the DSP indicator goes off from the display.
Now, you are ready to start adjustments.
•To adjust the output balance for the front speakers, go to the next
step.
•To adjust the output level for the subwoofer, go to step
4
.
00 F 00 00 R 00 CEN
Normal indication
(canceled) SW REAR
00 F 00 00 R 00 CEN
Normal indication
(canceled) SW REAR
3
To adjust the output balance for the front
speakers
1) Press SOUND repeatedly until the
adjustment indication for the front
speakers appears on the display.
•Each time you press the button, the adjustment indication
on the display changes as follows:
2) Press 3 or 2 to adjust the
output balance.
3: Decreases the left speaker
output, or restores the right
speaker output.
2: Decreases the right speaker
output, or restores the left
speaker output.
•The output balance changes from
OFF (silence), –06 (most reduction) to 00 (no reduction).
•“00 F 00” is the initial setting (the output balance is at the
center position). If you have already changed the setting,
another value will appear.
4
To adjust the output level for the subwoofer
1) Press SOUND repeatedly to select
“SW.”
•Each time you press the button, the indication on
the display changes as follows:
2) Press 3 or 2 to adjust the
output level.
3: Increases the output level.
2: Decreases the output level.
•The output level changes from –06
to +06.
•“SW –06dB” is the initial setting.
If you have already changed the
settings, another value will appear.
DSP MODE
PRO LOGIC
SOUND
ENTER
ENTER
SOUND
DSP MODE
EN18-24TH-A5[C]f.pm6 01.12.25, 13:5820