A Mail Settings |
| For setting the mail options when [Mail] is selected as the action on the | |||
|
| Alarm page. If an SMTP server, a port number or a sender's mail | |||
| H257VPU/H157WPU |
| address has been set, "Preset" will be displayed. | ||
| only) |
|
|
|
|
|
|
|
| ||
| SMTP Server |
| Sets the IP address or FQDN of the SMTP server. | ||
|
|
| Memo: |
|
|
|
|
|
| ||
|
|
| FQDN (Fully Qualified Domain Name) | ||
|
|
| This refers to a domain name that has been completely specified, without | ||
|
|
| abbreviation of the host or domain names on a TCP/IP network. | ||
|
|
| For example, with a host name of www and a domain name of | ||
|
|
| victor.co.jp, the FQDN representation is "www.victor.co.jp". | ||
|
|
| Japanese cannot be used in a FQDN. If you have configured an FQDN, | ||
|
|
| configure a DNS server on the Network Basic page as well. (A Page 59) | ||
|
|
|
|
| |
|
|
|
| ||
| Port Number |
| Enter the port number. | ||
|
|
| [Set values: 0 - 110 - 65535] | ||
|
|
|
| ||
| Send Mail Address |
| Set the sender's mail address. | ||
|
|
|
|
|
|
POP To enable [POP before SMTP], select "Enable" and set up the POP server.
before POP Sets the IP address or FQDN of the POP server.
SMTP Server
|
| Port | Enter the port number. |
|
| Number | [Set values: 0 - 110 - 65535] |
|
|
|
|
|
| User | Enters a user name. |
|
| Name |
|
|
|
|
|
|
| Password | Enters a password. |
|
| ||
B Alarm output | Configure settings related to alarm output from an alarm output cable or | ||
|
|
| connector. |
|
|
|
|
| Duration | Sets the output duration for [Manual Output]. | |
| [Set values: 0/ 100 - 1000 - 5000] msec | ||
|
|
| |
|
|
|
|
|
|
| Manually operate alarm output. |
|
|
| The current output status is displayed on the right side. When [Duration] |
|
|
| is set to "0", pressing the [Make] button sets the alarm to make output, |
|
|
| and pressing the [Break] button sets the alarm to break output. |
| Manual Output | When [Duration] is set to other than "0", pressing the [Make] button sets | |
| the alarm to make output only for the output duration time, and then | ||
|
|
| |
|
|
| changes it to break output. |
|
|
| When [Duration] is set to other than "0", pressing the [Break] button sets |
|
|
| the alarm to break output only for the output duration time, and then |
|
|
| changes it to make output. |
|
|
|
|
|
|
| * The [Set values] in bold letters are factory defaults. |
41