Please follow these instructions carefully
for troublefree cleaning.
Use the diagram on Page 8 for reference purposes.
3.2Water Connection
•The minimum length of supply hosepipe advised for maximum user convenience is 7.5 metres with a diameter of 12.5 mm (1/2") to allow free flow of inlet water to the machine so avoiding backpressure and any associated potential damage to your machine.
•Attach your supply hosepipe with its connector to the coupling on the machine (No.9) and the other end should be connected to a suitable water supply.
3.3Electrical Connection
•Ensure the Power Switch (No.4) is in the “OFF” position before connecting the factory fitted Plug attached to the Mains Electric Lead (No.5) into an earthed socket. (it is recommended that an RCD plug socket is used.)
If using an Extension Cable make sure it is completely unwound from the cable drum and is the correct diameter.
3.4Suction Mode - an added benefit of the Karcher Pressure Washer
•If you are drawing water from a static water supply such as a water butt disconnect the water connection/hosepipe with coupling (No.9) from the machine and replace with a suction hose and filter (Part No. 4.440.238) that can be purchased as an accessory.
•Disconnect the Spray Lance from the Spray Gun.
•Allow the pressure washer to operate without the Spray Lance fitted until water flows from the Spray Gun without bubbles.
•
Dirt in the drawn water could damage your Pressure Washer ! To avoid this risk please use a suitable filter - Part No.
9
