English

FOR YOUR SAFETY!

General instructions

It is mandatory to read and observe this prior to using the appliance!

♦Notify your sales outlet if during unpacking you detect damage that has occurred in transit.

♦Read the operating instructions of your appliance prior to putting it into operation, especially the safety information.

♦Read the safety notes for sweepers and vacuum sweepers 5.956-250 prior to their start-up.

♦The danger and caution signs attached to the appliance give important tips on its safe operation.

♦In addition to the instructions in the operating instructions, general safety- and accident prevention-regulations from lawgivers must be followed.

Use

♦Prior to utilization the appliance and its working facilities must be checked regarding their proper condition and that they operate safely. It must not be used if its condition is not faultless.

♦No modifications permitted on the machine.

♦Never absorb explosive liquids, inflammable gases or undiluted acids and solvents! This includes petrol, paint thinner or fuel oil, which can form explosive fumes due to the swirling suction air, in addition acetone, undiluted acids and solvents, since they corrode the materials used for the appliance.

♦Do not sweep up/absorb burning or smouldering objects.

♦Only if expressly marked as such is this appliance suitable for sucking up health-hazardous dust types.

Comply with notices concerning safety regulations given in the operating instructions.

♦This unit is suitable only for the surfaces listed in the operating instructions.

♦The appliance may be used on only the areas cleared for its use by the factory owner or a person authorized by him.

♦Keep clear of the danger area. Its operation in explosion hazardous locations is prohibited.

♦The following applies generally: Keep combustible materials away from the machine (danger of explosions-/fire).

Operation

♦The rules, regulations and stipulations applying to motor vehicles must always be observed.

♦The operator must use the unit in accordance with its intended purpose. She must adapt her mode of operation to the local conditions and when working with the appliance keep a look out for third parties, especially children.

♦The appliance may only be used by persons instructed in its handling or who have proved their capability of operating it and who are expressely authorized to use it.

♦The unit must not be operated by children and youths.

♦To prevent unauthorized utilization of appliances provided with an ignition key the ignition key must be removed.

♦The appliance must never be left unattended as long as the motor is running. The operator may not leave the appliance until the motor is turned off, the appliance is safeguarded against unintentional motion, if necessary the parking brake actuated and the ignition key removed.

KMR 1550 D

♦On slopes the angle of inclination to the side and in the direction of motion must not exceed the value given in the operating instructions.

Transport

♦Shut down engine.

♦Lock the hand brake.

♦Secure the machine with guy belts, cables or chains.

♦Secure the machine with wedges on the wheels.

Maintenance

♦Repair/overhaul work may be performed only by approved after- sales service stations or experts familiar with all relevant safety regulations.

♦Industrially used appliances in changing locations are subject to the safety inspection according to VDE 0701.

♦Prior to beginning work on the electrical equipment of battery- driven units the battery plug connection must be unplugged or the battery disconnected and the battery must be disconnected in the case of combustion engine driven units.

♦Prior to cleaning it and performing maintenance work, changing parts or setting it to another function the appliance is to be switched off and if necessary the ignition key removed.

♦Unless expressly permitted the unit may not be cleaned with hose or high-pressure water jets.

(Danger of short circuits or other damage).

Accessories and spare parts

♦Only accessories and spare parts cleared by the manufacturer may be used. Genuine accessories and spare parts guarantee that the appliance can be operated safely and trouble-free.

Riding appliances

♦Riding appliances are not approved for public highways. Please ask your retailer for the conversion kit for street-worthiness.

♦Giving companions lifts is not permissible.

♦Riding appriances may be set in motion only from the seat.

Units with combustion engines

♦The exhaust opening must not be sealed.

♦Do not bend over or touch the exhaust opening (danger of burns).

♦Do not touch or grasp the drive motor (danger of burns).

♦Provision for adequate ventilation and removal of the waste (exhaust) gas must be made when operating the appliance indoors. (Danger of poisoning)

♦Exhaust gases are toxic and damaging to health; do not inhale them.

♦The engine takes approx. 3...4 s to run down after being shut off.

Never enter operating area during this period!

The following must be heeded when filling up combustion engine units:

♦Only the fuel specified in the operating instructions may be used. An explosion hazard exists with unsuitable fuels.

♦The motor must be turned off.

♦Do not fill-in fuel in closed rooms.

♦Take care that no fuel splashes onto hot surfaces.

♦Do not use any burning or smouldering objects during filling up or carry them with you or bring them in the vicinity of the appliance (explosion hazard).

♦Fill the tank at the most 1 cm below the lower edge of the filler neck, since the fuel expands in heat.

♦Wipe-up spilt fuel and close the tank lid tightly.

22

Tip hazard if slope too steep!

♦The machine can tip over while being driven on gradients transverse to travel path.

♦The machine can tip over while being turned on gradients.

♦In direction of travel only negotiate gradients up to 25 %.

♦At right angles to direction of travel only negotiate gradients up to

10 %.

Seat contact switch

When the driver's seat is vacated with the engine running, the engine must switch off.

If the engine does not switch off, the seat contact switch is defective. Inform After-Sales Service.

Power drive

The engine takes approx. 3...4 s to run down after being shut off. Never enter operating area during this period!

Caution when machine is running

The main brush centring also rotates. (See "replacing main brush")

Do not engage in this area when machine is running.

Page 21 Page 23
Page 22
Image 22
Karcher KMR 1550 D manual English, For Your Safety
Page 21 Page 23

KMR 1550 D specifications

The Karcher KMR 1550 D is a robust and versatile ride-on mower specifically designed for maintaining large green spaces with ease and efficiency. As part of Karcher's impressive lineup of outdoor cleaning and landscaping equipment, the KMR 1550 D combines innovative technology, user-friendly features, and high performance.

One of the standout features of the KMR 1550 D is its powerful diesel engine, which ensures reliability and longevity even during intensive use. This engine provides sufficient power to tackle various terrains, allowing users to efficiently cut grass in parks, sports fields, and larger residential lawns. The mower's cutting deck spans 155 centimeters, enabling it to cover significant ground quickly, reducing the time required for mowing large areas.

The state-of-the-art cutting technology incorporated into the KMR 1550 D includes a robust three-blade system, designed to provide a clean and even cut. This system minimizes uncut grass patches and promotes healthy lawn growth by ensuring that clippings are evenly distributed. The machine also features adjustable cutting heights, allowing users to select from multiple grass lengths for optimal results based on specific requirements.

For user comfort and control, the KMR 1550 D is equipped with a spacious and ergonomic operator platform. The intuitive dashboard layout includes easy-to-read gauges, making it simple for operators to monitor performance metrics at a glance. Additionally, the steering system is designed for exceptional maneuverability, making it easy to navigate around obstacles and tight spaces without difficulty.

Another notable technology included in this model is the innovative hydrostatic transmission, which provides smooth and responsive control of speed and direction. This feature allows users to adjust their pace seamlessly without interrupting their mowing workflow. Additionally, the mower's oversized tires offer excellent traction and stability, ensuring that it performs well on uneven surfaces.

The Karcher KMR 1550 D is also designed with maintenance in mind. Its easily accessible components simplify routine checks and servicing, reducing downtime and maximizing productivity. The durable construction of the mower ensures that it can withstand the rigors of commercial use, making it a reliable investment for professional landscapers and maintenance crews.

In summary, the Karcher KMR 1550 D stands out in the market for its powerful performance, advanced cutting technology, and user-friendly design. It is an ideal choice for anyone looking to maintain large green areas efficiently and effectively while enjoying the comfort and convenience of a ride-on mower. Whether for commercial use or for maintaining extensive residential properties, the KMR 1550 D delivers exceptional results time after time.
Top Page Image Contents