Main menu - Channel search
Symbol Rate
Use the numeric keypad to enter the relevant symbol rate.
Channel search mode
Use the buttons to select the type of channels that are to be searched for. You have three options:
- | “free & scrambled” | All channels are searched for |
- | “only free” | Only |
- | “only scrambled” | Only encrypted channels are searched for |
To view encrypted channels you need an appropriate CA (Conditional Access) module and a valid smart card together with a valid subscription to the relevant Pay TV provider.
Network Search
Use the buttons (On/Off) to select whether a network search should be performed. If you set the network search to “Off”, only the factory default transponders for the satellite(s) you previously selected will be searched for new as yet unsaved channels. If you set the network search to “On”, the transponder network enables additional transponders that have not yet been stored to be located. They are then stored and searched for new channels in the
same way as the existing transponders. Once you have made all the settings, use the buttons to switch to the
“Start search” field and confirm the start of the search using the button.
Search with service ID
After calling up the menu you will see the following display:
The buttons allow you to select different sets of parameters for the search.
Satellite
Use the buttons to select the satellite that is transmitting the channels to be searched. By pressing the button
at this point you can view a list of the installed satellites. Use the buttons to select the satellite you want and confirm
your selection with the button. Make sure your reception system is aligned to this/these selected satellite(s).
103