TTOO CCHHAANNGGEE LLAASSEERR BBAATTTTEERRIIEESS::
1. Open battery compartment cover.
2. Make sure batteries are correctly positioned accord-
ing to the positive/negative markings on the compart-
ment.
3. Close cover.
OOPPEERRAATTIINNGGTTHHEE CCIIRRCCUULLAARR SSAAWW
BBee aawwaarree tthhaatt tthhiiss ttooooll iiss aallwwaayyss iinn aann ooppeerraattiinngg ccoonnddiittiioonn
bbeeccaauussee iitt ddooe
ess nnoott hhaavvee ttoo bbee pplluuggggeedd iinnttoo aann eelleeccttrriiccaall oouuttlleett..Always turn
the switch ““OOFFFF””and remove the battery pack before changing bits.
OOPPEERRAATTIINNGG TTHHEE TTRRIIGGGGEERR SSWWIITTCCHH
NNeevveerr ttaappee tthhee ttrriiggggeerr sswwiittcchh ddoowwnn ttoo pprroovviiddee
ccoonnttiinnuuoouuss hhiigghh ssppeeeedd..The tool may fail under such conditions causing fire
or personal injury.
TThhee lloocckk--ooffff bbuuttttoonn hheellppss pprreevveenntt aacccciiddeennttaall ssttaarrttiinngg..
This button can be pressed from either side.
TTHHIISS TTOOOOLL IISS CCOONNTTRROOLLLLEEDD BBYY
AA TTRRIIGGGGEERR SSWWIITTCCHH:
:
Press the lock-off button, then
pull the ““OONN//OOFFFF””trigger to turn
the Circular Saw ““OONN””.
To turn the Circular Saw ““OOFFFF””,
release the trigger switch. The
lock-off button will automatically
reset.
22
• Mark the desired line of cut so it is easily visible.
• Set the shoe against the work piece.
• Push laser ““OONN//OOFFFF””switch to ““OONN””.
• Adjust the laser line until it lines up with the cut line marking. Blade will now be
in the proper position to make your cut.
• Pull the trigger to start the saw.
• When the blade reaches full speed, slowly feed the blade into the work piece.
When the blade starts cutting, release the blade guard.
• DDOO NNOOTTforce saw. Allow saw to cut at its own rate.
• Cut straight lines only. Attempting to cut a curve will bend the blade which could
result in personal injury or damage to the tool.
• If you need to stop in the middle of a cut, turn off the saw and allow it to come
to a complete stop before removing it from the material.
• When the cut is finished, turn off the laser light.
RREEPPLLAACCIINNGG LLAASSEERR BBAATTTTEERRIIEESS
The laser runs on two AAA batteries which are located beneath the ““OONN//OOFFFF””
switch.
When the laser light begins to dim, change both batteries.
Remove batteries before putting the circular saw into storage. Batteries may leak
and cause damage if the laser is not used for over 90 days.
21
TRIGGER
LASER ON/OFF SWITCH
PENCIL LINE
LASER LINE
CAUTION LABEL
LOCK-OFF BUTTON
TRIGGER
SWITCH