This chart shows examples of items that can be rack dried and the suggested temperature setting and drying time. Actual drying time will depend on the amount of moisture items hold.
Rack | Dry |
| Setting | Temp. | Time* | |
Wool | Sweaters | Timed | Low | 60 | ||
Block | to | shape and lay flat on | Cycles |
|
| |
the rack. |
|
|
|
|
| |
Stuffed | toys | or pillows | Timed | Low | 60 | |
Cotton | or polyester fiber filled | cycles |
|
| ||
Stuffed | toys | or pillows | Timed | Air Only | 90 | |
Foam | rubber | filled | cycles | (no |
| |
|
|
|
|
| heat) |
|
Sneakers or canvas shoes | Timed | Air Only | 90 | |||
|
|
|
| cycles | (no |
|
|
|
|
|
| heat) |
|
*(Minutes) Reset time to complete drying, if needed.
DRYER CARE
Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air.
Explosion Hazard
Keep flammable materials and vapors, such as gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor for a garage installation.
Failure to do so can result in death, explosion, or fire.
Every load cleaning
The lint screen is located in the door opening of the dryer. The control panel has an indicator light to remind you to clean the lint screen before each load. A screen blocked by lint can increase drying time.
To clean
1.Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove.
2.Push the lint screen firmly back into place.
IMPORTANT:
•Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics.
Some towels made of synthetic fibers and natural fibers (polyester and cotton blends) may shed more lint than other towels, causing your dryer's lint screen to fill up faster. Be sure to remove lint from the lint screen before and after drying new towels.
•If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. See "Venting Requirements."
As needed cleaning
Laundry detergent and fabric softener residue can build up on the lint screen. This buildup can cause longer drying times for your clothes, or cause the dryer to stop before your load is completely dry. The screen is probably clogged if lint falls off the screen.
Clean the lint screen with a nylon brush every 6 months, or more frequently, if it becomes clogged due to a residue buildup.
To wash
1.Roll lint off the screen with your fingers.
2.Wet both sides of lint screen with hot water.
3.Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup.
4.Rinse screen with hot water.
5.Thoroughly dry lint screen with a clean towel. Replace screen in dryer.
21
