98 English
English
Troubleshooting Guide
The viewing angle cannot be changed.
•The DVD disc being played does not contain the
recording of more than one angle.
•You are attempting to switch the angle in a DVD
section where more than one angle is not recorded.
Playback will not start even after a title is selected.
•A viewing restriction (RATING) has been set for the
disc.
The voice or subtitle language selected in the initial setting is not played.
•The DVD disc being played does not contain the
recording of the selected voice or subtitle language.
Disc source
The disc control mode cannot be selected.
•No wire has been connected to the disc changer
input terminal on the unit.
The specified disc does not play, but another one plays instead.
•The specified CD is quite dirty.
•The CD is upside-down.
•The disc is loaded in a different slot from that
specified.
•The disc is severely scratched.
The sound skips.
•Something is touching the disc changer.
•The CD is scratched or dirty.
The display shows that the changer is being played, but no sound can be heard.
•The computer chip in the unit is not functioning
normally.
The specified track will not play.
•Random play or magazine random play has been
selected.
Track repeat, disc repeat, track scan, disc scan, random play, and magazine random play start by themselves.
•The setting is not cancelled.
Can’t remove disc.
•The cause is that more than 10 minutes has elapsed
since the vehicle ACC switch was turned OFF.
•The viewing angle cannot be changed when the DVD disc
being played does not contain the recording of more than
one angle.
•More than one viewing angle may be recorded only in
limited sections in a disc.
•Check the viewing restriction level (RATING) setting.
•Use a DVD disc containing the recording of the selected
voice or subtitle language.
•Connect the wire to the disc changer input terminal on the
unit.
•Clean the CD.
•Load the CD with the labeled side up.
•Eject the disc magazine and check the number for the
specified disc.
•Try another disc instead.
•Remove whatever is touching it.
•If skipping happens at the same place when the car is
stopped, something with the CD is wrong. Clean the CD.
•Press the reset button on the unit (see page 4).
•Turn off random play or magazine random play.
•The settings for these functions remain on until the
setting to off or the disc ejected, even if the power is
turned off or the source changed.
•The disc can only be removed within 10 minutes of the
ACC switch being turned OFF. If more than 10 minutes
has elapsed, turn the ACC switch ON again and press the
Eject button.
DDX7015/7045_K(En)v3.9 04.4.18 9:43 AM ページ98