Kenwood DPX301 The messages shown below display your systems condition

The messages shown below display your systems condition.

EJECT:	No disc magazine has been loaded in
	the changer. The disc magazine is not
	completely loaded.
	➪ Load the disc magazine properly.
	No CD in the unit.
	➪ Insert the CD.
NO DISC:	No disc has been loaded in the disc
	magazine.
	➪ Load a disc into the disc magazine.
TOC ERR:	No disc has been loaded in the disc
	magazine.
	➪ Load a disc into the disc magazine.
	The CD is quite dirty. The CD is upside-
	down. The CD is scratched a lot.
	➪ Clean the CD and load it correctly.
E-05:	The CD is upside-down.
	➪ Load the CD correctly.
BLANK:	Nothing has been recorded on the MD.
NO TRACK:	No tracks are recorded on the MD,
	although it has a title.
E-15:	Media was played that doesn’t have data
	recorded that the unit can play.
	➪ Use media that has data recorded that
	the unit can play.
NO PANEL:	The faceplate of the slave unit being
	connected to this unit has been removed.
	➪ Replace it.
E-77:	The unit is malfunctioning for some reason.
	➪ Press the reset button on the unit. If the
	"E-77" code does not disappear, consult
	your nearest service center.
E-99:	Something is wrong with the disc
	magazine. Or the unit is malfunctioning for
	some reason.
	➪ Check the disc magazine. And then
	press the reset button on the unit. If the
	"E-99" code does not disappear, consult
	your nearest service center.
HOLD:	The protective circuit in the unit activates
	when the temperature inside the
	automatic disc changer exceeds 60°C
	(140°F), stopping all operation.
	➪ Cool down the unit by opening
	the windows or turning on the air
	conditioner. As the temperature falls
	below 60°C (140°F), the disc will start
	playing again.
LOAD:	Discs are being exchanged in the Disc
	changer.

READING:	The unit is reading the data on the disc.
IN (Blink):	The CD player section is not operating
	properly.
	➪ Reinsert the CD. If the CD cannot be
	ejected or the display continues to flash
	even when the CD has been properly
	reinserted, please switch off the power
	and consult your nearest service center.
PROTECT:	The speaker wire has a short-circuit or
	touches the chassis of the vehicle, and
	then the protection function is activated.
	➪ Wire or insulate the speaker cable
	properly and press the reset button.
NA FILE:	An Audio file is played with a format that
	this unit can’t support.
	➪ ----
COPY PRO:	A copy-protected file is played.
	➪ ----

DEMO MODE: The Demonstration mode has been selected.

➪The <Demonstration mode Setting> (page 25) is ON. Turn it OFF.

English 35