Kenwood DVR-5070

DVR-5070 (EN)

Knowledge

÷Connect properly referring to “System con-

nection”.

÷Switch MUTE OFF.

÷Unplug the headphone plug.

÷Set the sound volume to an appropriate

level.

÷Connect properly referring to “System con-

nection”.

÷Connect antennas.

÷Select a band.

÷Tune to the frequency of the desired sta-

tion.

÷Install the outdoor antenna in an apart posi-

tion from the road.

÷Use the outdoor antenna.

÷Switch the suspected electric appliance OFF.

÷Install the TV or the system at an increased

distance between them.

÷Connect the wire with the white tube to the

lower side (+ side).

÷Preset stations with tunable frequencies.

÷Preset stations again.

÷Reset the microcomputer.

÷Check the speaker connection. If this does

not help, contact your dealer for service.

÷Leave the unit for about 15 minutes in

standby condition to cool down, and then

perform power ON.

During standby, the standby indicator will

flash faster than normal, but when it goes

out, the unit has returned to normal condi-

tion.

If normal return is not obtained even when

this operation has been repeated, contact

your dealer for service.

÷Select Surround with the LSTN M. key.

÷The speaker cords are disconnected.

÷The MUTE switch of remote control unit is

switched ON.

÷The headphone plug is inserted into the jack.

÷The volume control of this set is not ad-

justed properly.

÷The speaker cords are disconnected.

÷The antennas have not been connected.

÷A proper broadcasting band has not been

selected.

÷The frequency of the station to be received

is not tuned.

÷Car ignition noise.

÷The accessory FM indoor antenna is being

used.

÷Influence of an electric appliance.

÷A TV set is installed near the system.

÷The connection of the AM loop antenna is

not correct.

÷The frequency of the preset station is not

tunable.

÷The preset memory has been cleared be-

cause the power cord has been unplugged

for a long period or operated to reset.

÷The speaker cord connection is not correct

or the operation of the microcomputer tem-

porarily has become abnormal.

÷The temperature protection inside the unit

has operated because of an excessive vol-

ume.

÷The LISTEN mode is STEREO.

What seems to be a malfunction is not always so. Before calling for service, check the following table according to the symptom

of your trouble.

Operation to reset

The microcomputer may fall into malfunction (impossibility

to operate, erroneous display, etc.) when the power cord is

unplugged while power is ON or due to an external factor. In

this case, execute the following procedure to reset the

microcomputer and return it to normal condition.

÷Please note that resetting the microcomputer clears the

contents stored in and returns and to condition when it left

the factory.

Sound is not produced.

Sound is not produced from the left

or right speakers.

Radio stations cannot be received.

Noise interferes.

A station has been preset but it can-

not be received by pressing the

P.CALL key.

Standby condition is reached by

power ON.

Standby condition is reached suddenly

while listening to music.

No sound from the surround speakers

RemedyCauseSymptom

Receiver, speakers

(

)

In case of difficulty

Set the POWER switch to ON (set to Standby

mode). Then press the ¢ key, 4 key and STOP

key in this order.