Kenwood DVT-6200

Knowledge

DVT-6200 (EN/K,E,X)

In case of difficulty

Operation to reset

What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the

table below to see if the problem can be corrected before seeking help from your dealer or service representative.

1Press the MENU key on the remote to enter SETUP

MENU.

2Select the PREFERENCE, then press the ENTER key.

3Select DEFAULTS, press the Cursoe right (3) key to

select RESET.

4Press the numeric keys as shown below.

Press 1, 3, 9, 7, then press the ENTER key.

When resetting is done according to this method, all set-

tings, including the settings for password and parental level,

will be reset to the factory defaults.

The microprocessor may fall into malfunction (impos-

sibility to operate erroneous display, etc.) when the

power cord is unplugged while power is ON or due to

an external factor.

In this case, switch off the power, wait for several sec-

onds, and then switch the power on again.

Return to the factory defaults by resetting the micropro-

cessor is done as shown as follows.

÷Connect properly referring to “System con-

nections”.

÷Switch MUTE OFF.

÷Unplug the headphone plug.

÷Connect properly referring to “System con-

nections”.

÷Connect antennas.

÷Select a band.

÷Tune to the frequency of the desired sta-

tion.

÷Install the outdoor antenna in an apart posi-

tion from the road.

÷Switch the suspected electric appliance OFF.

÷Install the TV or the system at an increased

distance between them.

÷Preset stations with tunable frequencies.

÷Preset stations again.

÷Check the speaker connection.

÷Check the speaker connection. If this does

not help, contact your dealer for service.

÷Select Surround with the LISTEN MODE

key.

÷The speaker cords are disconnected.

÷The MUTE switch of remote control unit is

switched ON.

÷The headphone plug is inserted into the jack.

÷The speaker cords are disconnected.

÷The antennas have not been connected.

÷A proper broadcasting band has not been se-

lected.

÷The frequency of the station to be received is

not tuned.

÷Car ignition noise.

÷Influence of an electric appliance.

÷A TV set is installed near the system.

÷The frequency of the preset station is not

tunable.

÷The preset memory has been cleared because

the power cord has been unplugged for a long

period.

÷The speaker connection is abnormal.

÷The LISTEN mode is STEREO.

Sound is not produced.

Sound is not produced from the left

or right speakers.

Radio stations cannot be received.

Noise interferes.

A station has been preset but it can-

not be received by pressing the

P.CALL key.

The STANDBY indicator flashes red.

No sound from the surround speakers

RemedyCauseSymptom

Receiver, speakers

›

ﬂ

‡

03.7.8, 11:04 AMPage 56