General Operation

Audio Control

1Select the source to adjust Press the [SRC] button.

2Enter Audio Control mode Press the [VOL] knob.

3Select the Audio item to adjust Press the [VOL] knob.

Adjustment Item

Display

Range

Subwoofer level*

“SW L”/“L SUB”

–15 — +15

System Q

“NATURAL/FLAT”/

Natural/Rock/Pops/Easy/

 

“ROCK”/“POPS”/

Top 40/Jazz/User setting

 

“EASY”/“TOP40/TP40”/

 

 

“JAZZ”/“USER”

 

Bass level

“BAS L”/“L BAS”

–8 — +8

Middle level

“MID L”/“L MID”

–8 — +8

Treble level

“TRE L”/“L TRE”

–8 — +8

Balance

“BAL”/“BL”

Left 15 — Right 15

Fader

“FAD”/“FD”

Rear 15 — Front 15

Exit Audio Control mode (Volume control mode)

*Function of KDC-MP238/MP238CR/MP208/138.

“USER”: This appears when Bass level, Middle level, and Treble level are adjusted. When “USER” is selected, these levels are recalled.

4Adjust the Audio item Turn the [VOL] knob.

5Exit Audio Control mode Press any button.

Press a button other than the [VOL] knob.

Audio Setup

Setting the Sound system.

1Select the source to adjust Press the [SRC] button.

2Enter Audio Setup mode

Press the [VOL] knob for at least 1 second.

3 Select the Audio Setup item to adjust

Press the [VOL] knob.

Adjustment Item

Display

Range

Low Pass Filter*

“LPF”

80/120/160/Through(OFF) Hz

Volume offset

“V-OFF”/“V-OF” –8 — ±0 (AUX: -8 — +8)

*Function of KDC-MP238/MP238CR/MP208/138.

Volume offset: Sets each source’s volume as a difference from the basic volume.

4Adjust the Audio setup item Turn the [VOL] knob.

5Exit Audio Setup mode

Press the [VOL] knob for at least 1 second.

Speaker Setting

Fine-tuning so that the System Q value is optimal when setting the speaker type.

1Enter Standby

Press the [SRC] button.

Select the “STANDBY”/ “STBy” display.

2Enter Speaker Setting mode Press the [VOL] knob.

3Select the Speaker type Turn the [VOL] knob.

Speaker type

Display

OFF

 

“SP OFF”/“SP-F”

For 5

& 4 in. speaker

“SP 5/4”/“SP-5”

For 6

& 6x9 in. speaker

“SP 6*9/6”/“SP-6”

For the OEM speaker

“SP OEM”/“SP-O”

4Exit Speaker Setting mode Press the [VOL] knob.

Function of KDC-MP238/KDC-MP238CR/KDC-MP208

Switching Display

Changing the information displayed.

1Enter Switching Display mode

Press the center of the Control knob for at least 1 second.

“DISP SEL” is displayed.

2Select the Display item

Press the right or left side of the Control knob.

In Tuner source

Information

Display

Frequency

“FREQ”

Clock

“CLOCK”

6 KDC-MP238/CR/KDC-MP208/KDC-138/CR