Connecting Wires to Terminals
USB connector
To USB device
Rear left output (White)
Rear right output (Red)
FRONT
•Do not remove the cap when you do not use the USB cable. The connector will cause the unit to malfunction if it gets in touch with any metallic part of the vehicle.
•Fasten the connector with the tape so that the cable will not come off.
Front right output (Red)
Front left output (White)
FM/AM antenna input
To connect these leads, refer to the relevant instruction manuals.
To Kenwood disc changer/ External optional accessory
Fuse (10A)
| Wiring harness |
If no connections are made, do not let the wire come out from the tab. | (Accessory1) |
When using the optional power amplifier, connect to its power control terminal.
Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the
Connect to the terminal that is grounded when either the telephone rings or during conversation.
To connect the Kenwood navigation system, consult your navigation manual.
To car light control switch
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
Power control wire (Blue/White)
P.CONT
Motor antenna control wire (Blue)
ANT.
CONT
TEL mute wire (Brown)
MUTE
Dimmer control wire (Orange / White)
ILLUMI
White/Black
White | FRONT L |
Gray/Black
Gray
FRONT R
Green/Black
Green
REAR L
Purple/Black
Purple
REAR R
Ignition key switch | Car fuse box |
| |
|
| ACC | Ignition wire (Red) |
Car fuse box |
|
| Battery wire (Yellow) |
(Main fuse) |
|
|
|
|
|
| Ground wire (Black) - (To car chassis) |
Battery + | – |
|
|
English 41