Audio Setup

Setting the Sound system, such as Cross over Network.

1Select the source to adjust Press the [SRC] button.

2Enter Audio Setup mode

Press the [VOL] knob for at least 1 second.

3Select the Audio Setup item to adjust Press the [VOL] knob.

Each time you press the knob, the item to be adjusted alternates between the items shown in the table below.

4Setup the Audio item Turn the [VOL] knob.

Adjustment Item

Display

Range

Front High Pass Filter

"HPF"

Through/40*/60*/80/100/120/

 

 

150/180/220* Hz

Rear High Pass Filter

"HPR"

Through/40*/60*/80/100/120/

 

 

150/180/220* Hz

Low Pass Filter

"LPF"

50*/60/80/100*/120/

 

 

Through Hz

Subwoofer Phase

"PHAS"

Reverse (180°)/ Normal (0°)

Volume offset

"V-OFF"

–8 — ±0 (AUX: -8— +8)

Loudness

"LOUD"

OFF/ON

Dual Zone System*

"2ZON"

OFF/ON

⁄

•* Function of KDC-X491

•Volume offset: Sets each source’s volume as a difference from the basic volume.

•Loudness: Compensates for low and high tones

during low volume. (Only the low tone is compensated for when the tuner is selected as a source.)

•Dual Zone System

Main source and sub source (Auxiliary input) output Front channel and Rear channel separately.

-Set up the channel of sub source by <Dual Zone System Setting> (page 24).

-Select Main source by [SRC] button.

-Adjust the volume of Front channel by [VOL] knob.

-Adjust the volume of Rear channel by <Audio Control> (page 8).

-The Audio Control has no effect on sub source.

•You can use the Dual Zone System with the internal auxiliary input.

5Exit Audio Setup mode

Press the [VOL] knob for at least 1 second.

Speaker Setting

Fine-tuning so that the System Q value is optimal when setting the speaker type.

1Enter Standby

Press the [SRC] button. Select the "STANDBY" display.

2Enter Speaker Setting mode Press the [VOL] knob.

3Select the Speaker type Turn the [VOL] knob.

Each time you turn the knob, the setting alternates between the settings shown in the table below.

Speaker type

Display

OFF

 

"SP OFF"

For 5

& 4 in. speaker

"SP 5/4"

For 6

& 6x9 in. speaker

"SP 6*9/6"

For the OEM speaker

"SP OEM"

4Exit Speaker Setting mode Press the [VOL] knob.

Subwoofer Output

Turning the Subwoofer output ON or OFF.

Push the Control knob toward down for at least 2 seconds.

Each time you push the knob, Subwoofer output switches ON and OFF.

When it is ON, "SW ON" is displayed.

English 9