Installation/Removing the Unit
Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place.
⁄
•Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (for example, the sound may skip).
Japanese cars
1Refer to the section <Removing the hard rubber frame> and then remove the hard rubber frame.
2Align the holes in the unit (two locations on each side) with the vehicle mounting bracket and secure the unit with the accessory screws.
TN
Removing the hard rubber frame
1Engage the catch pins on the removal tool and remove the two locks on the upper level. Upper the frame and pull it forward as shown in the figure.
Lock
Catch
Accessory2
Removal tool
2When the upper level is removed, remove the lower two locations.
⁄
•The frame can be removed from the bottom side in the same manner.
Removing the Unit
1Refer to the section <Removing the hard rubber frame> and then remove the hard rubber frame.
2Insert the two removal tools deeply into the slots on each side, as shown.
N T
T/N
T: Toyota cars
N: Nissan cars
3Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside.
Accessory2
|
| 8 mm | 8mm |
|
| MAX. | |
|
| MAX. | |
| 3 |
| |
|
| 4 | |
|
|
| |
ø5mm |
|
| ø5mm |
Accessory3...for Nissan car
Accessory4...for Toyota car
¤CAUTION
Install this unit in the console of your vehicle.
Do not touch the metal part of this unit during and shortly after the use of the unit. Metal part such as the heat sink and enclosure become hot.
¤
•Be careful to avoid injury from the catch pins on the removal tool.
4Pull the unit all the way out with your hands, being careful not to drop it.
46