Help? Troubleshooting

General

?The power does not turn ON.

✔ The fuse has blown.

After checking for short circuits in the wires, replace the fuse with one with the same rating.

✔The speaker wire has a short-circuit or touches the chassis of the vehicle, and then the protection function is activated.

Wire or insulate the speaker cable properly and press the Reset button.

✔A security code has been set.

Enter the set security code (page 47).

?No sound can be heard, or the volume is low.

✔The fader or balance settings are set all the way to one side.

Center the fader and balance settings.

✔The "AMP" feature in Menu setup is "OFF".

Turn the "AMP" feature "ON", referring to <Menu setup> section (page 44).

✔The values for Volume offset are too low.

Turn up the Volume offset, referring to the <Audio setup> section (page 37).

✔The input/output wires or wiring harness are connected incorrectly.

Reconnect the input/output wires or the wiring harness correctly. Refer to the <Connections> section (page 70).

?The sound quality is poor or distorted.

✔One of the speaker wires is being pinched by a screw in the car.

Check the speaker wiring.

✔The speakers are not wired correctly.

Reconnect the speaker wires so that each output terminal is connected to a different speaker.

?The TEL mute function does not work.

✔The TEL mute wire is not connected properly.

Connect the wire correctly, referring to the <Connections> section (page 70).

?The TEL mute function turns ON even though the TEL mute wire is not connected.

✔The TEL mute wire is touching a metal part of the car.

Pull the TEL mute wire away from the metal part of the car.

?The memory is erased when the ignition is turned OFF.

✔The ignition and battery wire are incorrectly connected.

Connect the wire correctly, referring to the <Connections> section (page 70).

?There’s no loudness effect.

✔You are using Subwoofer preout.

Loudness has no effect in Subwoofer preout.

?Even if Loudness is turned ON, high-pitched tone is not compensated for.

✔ Tuner source is selected.

High-pitched tone is not compensated for when in Tuner source.

?Radio reception is poor.

✔The car antenna is not extended. Pull the antenna out all the way.

✔The antenna control wire is not connected.

Connect the wire correctly, referring to the <Connections> section (page 70).

?There is a source you cannot switch.

✔The Disc changer is not connected.

Connect the Disc changer. If the Disc changer is not connected to it’s input terminal, You can’t switch to an external disc source.

?The display blacks out while scrolling.

✔The "DISP" feature under <Menu setup> is "OFF".

Turn the "DISP" feature "ON", referring to the <Menu setup> section (page 44).

Help?

English 61