— 21—
Cassette tape source
?Can’t remove tape.44
✔The cause is that more than 10 minutes has elapsed since the vehicle
ACC switch was turned OFF.
☞The tape can only be removed within 10 minutes of the ACC
switch being turned OFF. If more than 10 minutes has elapsed,
turn the ACC switch ON again and press the Eject button.
?The Tape Advance and Music Repeat don’t operate correctly.45
✔The space between the songs on the tape can’t be recognized
because it’s too short.
☞Have at least 4 seconds between songs.
✔The space between songs can’t be recognized because there’s too
much noise between songs.46
☞Reduce the noise between songs.
?The blank skip doesn’t work.47
✔Because noise is too loud, the non-recorded part can’t be recognized.
☞Reduce the noise between songs.
?Blank Skip functions at places that are recorded.48
✔Because the recording level is low, it’s recognized as not recorded.
☞Turn Blank Skip OFF.
Disc source
?"AVin" is displayed without achieving External disc control mode.50
✔O-N switch is set to "O" side.
☞Set the switch to "N" side.
✔Unsupported disc changer is connected.51
☞Connect the supported disc changer. (page 3)
?The specified disc does not play, but another one plays instead.52
✔The specified CD is quite dirty.
☞Clean the CD.
✔The CD is upside-down.53
☞Load the CD with the labeled side up.
✔The disc is loaded in a different slot from that specified.54
☞Eject the disc magazine and check the number for the specified
disc.
✔The disc is severely scratched.55
☞Try another disc instead.
?The specified track will not play.58
✔Random play or magazine random play has been selected.
☞Turn off random play or magazine random play.
?Track repeat, disc repeat, track scan, random play, and magazine
random play start by themselves.59
✔The setting is not canceled.
☞The settings for these functions remain on until the setting to off
or the disc ejected, even if the power is turned off or the source
changed.
?Cannot play CD-R or CD-RW.60
✔Finalization processing is not being conducted for CD-R/CD-RW.
☞Conduct finalization processing with CD recorder.
✔A non-compatible CD changer is being used to play the CD-R/CD-
RW.61
☞Use a CD changer compatible with CD-R/CD-RW to play.
?Track Search can't be done.66-2
✔For the albums first or last song.
☞For each album, Track Search can't be done in the backward
direction for the first song or in the forward direction for the last
song.
If the following situations, consult your nearest service
center:
•Even though the disc changer is connected, the Disc Changer source is
not ON, with "AVin" showing in the display during the Changer Mode.
•Even though no device (KCA-S210A, CA-C1AX, KDC-CPS87, KDC-CX87,
KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected, the
Auxiliary input is entered when switching modes.
KRC-335(K)_U.S r2 01.9.27 3:38 PM Page 21