Kenwood KRF-V7771D

KRF-V7771D (En/T)

Setup

Code selection after mode download

After successful completion of the download, step 5 of the previous page, the remote control automatically enters a special

set-up mode which works as described below.

Set up all the downloaded codes.

Select the input and component names that you want to register a setup code.

Find out the numeric icon that outputs the power code of the component.

Though the “Futureset” memory in your remote control is quite large, only 20 different devices power codes can be put on the keypad at any

one time. If you require a larger download, the standard setup procedure can be used. See “Assigning the connected components to the

selected inputs”, your customer service representative can supply you with the downloaded setup codes numbers.

Repeat the operations of step 1 and 2.

1Select the input name by selecting the or icon of

“Selector” (input selector).

This changes the section of “Video1” in the figure.

2Select the component name by selecting the or icon

of “Device” (component connected to the rear panel input

jacks).

This changes the section of “VCR” in the figure.

3Select the “Next” icon.

The “Register Info.2” menu screen appears.

1Select the

icon to output its power code.

÷After selecting a numeric icon, be sure to press the ENTER key to

output its power code.

2Select numeric icons in order from“

”until the compo-

nent selected in step 1 is turned ON (i.e. repeat step 1 for

each numeric icon).

3Select the “Entr” icon after the component has turned ON.

÷The setup code for the last power code to be sent in step 2 is

automatically registered at the location selected in step 1.

To delete a setup code

1Open the “Setup IR” menu screen shown on the left.

÷Follow the step 1 of “Assigning the connected components to

the selected inputs”.(

2Select the component to be deleted.

Select the component with the “ ”or “ ” icon.

3Select the 4 digit code “9999”.

4Select the “Entr” icon.

÷Once the setup code is registered and you switch to a different

menu screen, the code display is back to “#0000”.

÷When a setup code has been downloaded, the section where

“#0000” displays “# - - - -”.

When setup codes of more than one components have been

downloaded, note that all of the codes are interrelated between

each other. Therefore, if any of them is deleted, you should

perform the procedure of “Setup of components which are not

listed in the Setup Codes chart” from the beginning.

Setup for controlling AV components

Setup IR

MD/Tape1 MD#0000

Entr

Clr

Check

123

456

789

Video1

Selector

VCR

Device

Entr

159

2610

3711

4812

13 17

14 18

15 19

16 20