50
Additional Information
Remote control unit
Cause
•Subwoofer is OFF.
•The remote control is set to a different operation
mode.
•Batteries are exhausted.
•The remote control unit is too far away from the
main system, controlling angle is too large, or
there is an obstacle between the receiver and
the remote.
•The audio cords and system control cords are
not connected properly.
•No software is loaded in the source component.
•An attempt is made to play a tape which is being
recorded in the cassette deck.
•The remote control has not been set to the
operation mode for the component you wish to
control.
•The microprocessor of the remote control mal-
functions.
Remedy
•Turn the subwoofer ON. ¡
•Press the source keys or source POWER keys
to select the appropriate operation mode.
•Replace with new batteries. )
•Operate the remote control unit within the
controllable range.
•Connect properly referring to “Setting up the
system”. 8
•Place software in the source component you
want to play.
•Wait until recording has completed.
•Press the source select keys or source POWER
keys to activate the operation mode for the
component you want to control before
operation fi
•Reset the microprocessor. o
Symptom
Subwoofer volume cannot be adjusted.
Remote control operation is not possible.
In case of difficulty