Kenwood NV-701

Preparation section

System connection

Accessories

FM indoor antenna

(1)

AM loop antenna

(1)

Remote control unit

(1)

RC-NV301

RC-NV301E

(For NV-301)

RC-NV701

RC-NV701E

(For NV-701)

Speaker cords

NV-301 (2)

NV-701 (6)

Batteries (R6/AA)

(2) AC plug adaptor (1)

(Speaker cords are provided in

the speaker package. Be sure to

check that the correct lengths

have been provided.)

Use to adapt the plug on the power

cord to the shape of the wall outlet.

(Accessory only for regions where

use is necessary.)

Unpacking

Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost.

Examine the unit for any possibility of shipping damage. If your unit is damaged or fails to operate, notify your dealer

immediately. If your unit was shipped to you directly, notify the shipping company without delay. Only the consignee (the

person or company receiving the unit) can file a claim against the carrier for shipping damage.

We recommend that you retain the original carton and packing materials for use should you transport or ship the unit in the future.

Keep this manual handy for future reference.

When unpacking the main unit

Plastic protective adhesives have been applied to the front panel of the main unit to prevent minor scratches to the front panel during shipping. Please

remove these adhesives before using this unit.

Connection of the system accessories

CAUTION

Note on Connection

Connect the components as shown in the diagrams. Do not plug the power cord into a power outlet until connections

are complete. The rear panel configuration varies depending on the models (countries or area).

FM indoor antenna AM loop antenna

The accessory antenna is for temporary indoor use

only. For stable signal reception we recommend

using an outdoor antenna. Remove the indoor

antenna if you connect one outdoors.

The supplied antenna is for indoor use. Place it

as far as possible from the main unit, TV sets,

speaker cords, and the power cord, and set it in

the direction that provides the best reception.

1Connect to the antenna terminal.

2Locate a position providing good reception.

3Fix the antenna in place.

GND

Assemble

12 3