OPERATING THROUGH REPEATERS
1
2
Repeaters, which are often installed and maintained by radio clubs, are usually located on mountain tops or
3other elevated locations. Generally they operate at
4higher ERP (Effective Radiated Power) than a typical station. This combination of elevation and high ERP
5allows communications over much greater distances
6than communications without using repeaters.
7Most repeaters use a receive and transmit frequency
8pair with a standard or
9transceiver to allow it to access. For details, consult
10your local repeater reference.
11 |
|
| |
12 |
|
| |
13 |
|
| |
14 |
|
| |
15 |
|
| |
16 |
|
| |
17 |
|
| |
18 |
|
| |
19 |
|
| |
20 | TX: 144.725 MHz |
| |
21 | TX tone: 88.5 Hz |
| |
RX: 145.325 MHz | TX: 144.725 MHz | ||
22 | |||
| TX tone: 88.5 Hz | ||
23 |
| RX: 145.325 MHz | |
|
|
qSelect a band.
wSelect a receive frequency.
eSelect an offset direction.
rSelect an offset frequency.
(Only when programming
tActivate the Tone function. (If necessary)
ySelect a tone frequency. (If necessary)
If you store the above data in a memory channel, you need not reprogram every time. See “MEMORY CHANNELS” {page 26}.
20