1The reverse function exchanges a separate receive and
2transmit frequency. So, while using a repeater, you can manually check the strength of a signal that you receive
3directly from the other station. If the station’s signal is
4strong, both stations should move to a simplex frequency
5and free up the repeater.
6 |
|
| MHz | 325 |
|
|
|
|
|
| 145 |
|
|
|
|
|
| . |
|
|
7 | 144 | .725 |
| MHz |
|
|
8 |
|
|
|
|
| |
|
|
|
|
|
| |
9 |
|
|
| 144.725 | MHz | |
|
|
|
|
| ||
10 |
|
|
|
|
| REV ON |
11 | TX: 144.725 MHz | TX: 144.725 MHz TX: 144.725 MHz | TX: 145.325 MHz | |||
12 | RX: 145.325 MHz | RX: 145.325 MHz RX: 145.325 MHz | RX: 144.725 MHz | |||
|
|
|
|
|
|
Press [REV] to switch the Reverse function ON (or
13OFF).
14• “R” appears when the function is ON.
15
STA CON PACKET96 BCONDUP
16 |
| 5 | 7 | 9 | |
17 |
|
|
|
|
|
|
|
|
|
| |
|
|
|
| ||
18 |
|
|
|
|
|
19Note:
20◆ If pressing [REV] places the transmit frequency outside the allowable range, then pressing the PTT switch causes an error beep to sound;
21transmission is inhibited.
22◆ If pressing [REV] places the receive frequency outside the allowable range, an error beep sounds and no reversal occurs.
23◆ Automatic Repeater Offset does not function while Reverse is ON.
◆You cannot switch Reverse ON or OFF while transmitting.
While using a repeater, ASC periodically monitors the strength of a signal that you receive directly from the other station. If the station’s signal is strong enough to allow direct contact without a repeater, the ASC indicator on the display begins blinking.
Press [REV] (1 s) to switch the function ON.
• “” appears when the function is ON.
STA CON PACKET96 BCONDUP
5 7 9
•While direct contact is possible, the ASC indicator blinks.
•To quit the function, press [REV] momentarily.
Note:
◆Pressing the PTT switch causes the ASC indicator to quit blinking.
◆ASC does not function if your transmit and receive frequencies are the same (simplex operation).
◆ASC does not function while scanning.
◆Activating ASC while using Reverse switches Reverse OFF.
◆If you recall a memory channel or the Call channel that contains Reverse ON status, ASC is switched OFF.
◆ASC causes receive audio to be momentarily intermitted every 3 seconds.
24