11 Select the desired band.
22 Press [MR] to enter Memory Recall mode.
3• The memory channel used last is recalled.
4
5
6
7
8
3 Press [UP]/ [DWN] to select the desired memory
9
channel.
10
11• To restore VFO mode, press [VFO].
12You can also recall a memory channel by direct entry
13from the keypad. In Memory Recall mode press [ENT],
14then enter the channel number. To recall channel 3, for
15example, press [ENT], [0], [0], [3].
Note:
16◆ When you recall an
17the display. Press [REV] to display the transmit frequency.
◆After recalling a memory channel, you may program data such as
18Tone or CTCSS. These settings, however, are cleared once you select another channel or the VFO mode. To permanently store the
19data, overwrite the channel contents {page 27}.
20
21
22
23
Use the following procedure to clear an individual memory channel. Full Reset {page 32} is a quick way to clear all memory channels.
1Recall the desired memory channel.
2Switch OFF the power to the transceiver.
3Press [MR]+ POWER ON.• A confirmation message appears.
• To quit clearing the memory channel, press [ESC].
4Press [MR] again.
• The contents of the memory channel are erased.
Note: If you have recalled a memory channel on the
28