CALL CHANNEL (TH-D7A ONLY)

1The Call channel can always be selected quickly no matter what mode the transceiver is in. For instance,

2you may use the Call channel as an emergency

3channel within your group. In this case, the Call/VFO

4scan {page 38} will be useful.

5The default frequency stored in the Call channel is 144.000 MHz for the VHF band and 440.000 MHz for the

6UHF band. The Call channel can be reprogrammed

7either as a simplex & repeater or odd-split channel.

8Note: Unlike channels 0 to 199 the call channel cannot be cleared.

9Recalling the Call Channel

Reprogramming the Call Channel

1 Select the desired band.

2 Press [VFO].

3 Select the desired frequency and related data (Tone, CTCSS, etc.).

When you program the Call channel as an odd-split channel, select a receive frequency.

4Press [F], [CALL].

The selected frequency and related data are stored in the Call channel.

The previous mode is restored.

10

11

1 Select the desired band.

To also store a transmit frequency, proceed to the next step.

122 Press [CALL] to recall the Call channel.

13

• “C” appears.

 

14

 

15

 

16

 

17

 

18• To restore the previous mode, press [CALL] again.

20

21

22

23

5Select the desired transmit frequency.

6Press [F].

7Press [PTT]+[CALL].

The transmit frequency is stored in the Call channel, and the previous mode is restored.

Note:

Transmit Offset status and Reverse status are not stored in an odd-split Call channel.

To store data other than frequencies, select the data in step 3 not step 5.

30