You may sometimes want to search for other stations or a clear frequency, near the frequency stored in a memory channel or the Call channel. In this case first transfer the contents of a memory channel or the Call channel to the VFO.
1Recall the desired memory channel or the Call channel.
2Press [F], [VFO].
•The entire contents of the memory channel or the Call channel are copied to the VFO.
Note:
◆A transmit frequency from an
◆Lockout status and memory names are not copied from a memory channel to the VFO.
◆If you recall the Call channel in step 1, simply pressing [UP]/ [DWN] also transfers the contents to the VFO. The frequency, however, is changed by one step.
When in this mode, the transceiver displays only memory channel numbers (or memory names if stored) instead of frequencies.
Press [A/B]+ POWER ON to switch the function ON (or OFF).
Note: You cannot switch this function ON if you have not used both bands A and B to store frequencies.
When in Channel Display mode, you can use only the following functions:
Power ON/OFF | Band Select | |
|
| |
Squelch Level Adjust | Monitor | |
|
| |
Transmit | Transmit Power Select | |
|
| |
Memory Channel Select | Direct Memory Channel | |
Entry | ||
| ||
Lamp ON | Lamp ON Latch | |
|
| |
Offset Direction Select | Reverse | |
|
| |
Full Duplex | Memory Scan | |
|
| |
Partial/ Full Reset | Tone Alert | |
|
| |
Transceiver Lock | Audio Balance Select | |
|
| |
Band Display Blank | 1750 Hz Tone | |
|
| |
DTMF Number (Stored) |
| |
Transmit |
| |
|
|
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
31