■Using Program Scan
11 Select the appropriate band.
22 Press [VFO] .33 Select a frequency equal to or between the
4programmed scan limits.
54 Press [VFO] (1 s).6• Scan starts at the frequency currently displayed.
7• The 1 MHz decimal blinks while scanning is in progress.
8• To reverse scan direction, press [UP] (upward scan)
9or [DWN] (downward scan).
10
11
12
13◆ If the step size differs between the lower limit and the upper limit,
CALL/VFO SCAN (TH-D7A ONLY)
Use Call/VFO Scan to monitor both the Call channel and the current VFO frequency on the selected band.
1Select the desired band.
2Press [VFO].
3Select the desired frequency.
4Press [CALL] (1 s) to start Call/VFO Scan.
• The 1 MHz decimal blinks while scanning is in progress.
5To quit Call/VFO Scan, press [ESC].
CALL/MEMORY SCAN (TH-D7A ONLY)
Use Call/Memory Scan to monitor both the Call channel and the desired memory channel.
1 Recall the desired memory channel. |
14
you cannot use Program Scan.
15 | ◆ If the current VFO frequency is within more than one |
programmed scan range, the range stored in the smallest | |
| channel number is used. |
16
17
18
19
20
21
22
23
2 | Press [CALL] (1 s) to start Call/Memory Scan. | |
| • | The 1 MHz decimal blinks while scanning is in progress. |
| • | The Call channel on the same band as of the selected |
|
| memory channel is used for Scan. |
3 | To quit Call/Memory Scan, press [ESC]. |
Note: The memory channel last used is scanned even if it has been locked out.
38