OPERATION FLOW
1The following steps should guide you to a good start of
uAccess Menu
2
APRS operation.
i Access Menu |
3q Press [TNC] to switch ON the TNC.
4• “” appears.
5
w Access Menu
6data band {page 55}.
7
8e On the data band select the same frequency as
9other stations in your group.
10• You may tune to the frequency of an appropriate digipeater {page 72}.
11
12Now you are ready to receive APRS data from other
13stations. Refer to “RECEIVING APRS DATA” {page 63}. To transmit your APRS data, proceed to
14step r.
15
16r Access Menu
17(9 digits max.) {page 66}.
18
19t If you have connected a GPS receiver, access Menu
20“NOT USED”.
21
22y Access Menu
23{page 67}.
comments {page 69}. |
oIf you want, access Menu
!0If you want, access Menu
!1If necessary, access Menu
!2Access Menu
!3If you selected “PTT” or “AUTO” in step !2, access Menu
!4Press [BCON]. If you selected “PTT” in step !2, then press and release the PTT switch. See page 74.
Note: When using your personal computer, set the same communication parameters as Packet Operation {page 54}. On the transceiver, press [TNC] twice to enter Packet mode; “PACKET” should appear.
62