PREPARATION
2
31 Position the two grooves on the inside bottom corners of the battery pack over the corresponding guides on
4the back of the transceiver.
5
6
7
8
9Guide
102 Slide the battery pack along the back of the
11transceiver until the release latch on the base of the transceiver locks the battery pack in place.
12
13
14
15
16
17
183 To remove the battery pack, push up the release
19 | latch, then slide the battery pack back. | |
| ||
20 | Release latch | |
21 | ||
| ||
22 |
| |
23 |
|
After installing the NiCd battery pack, charge the battery pack. The battery pack is provided uncharged.
1Confirm that the transceiver power is OFF.
•While charging the battery pack, leave the transceiver power OFF.
2Insert the DC plug from the charger into the DC IN jack on the transceiver.
DC IN jack3Insert the charger AC plug into an AC wall outlet.
•Charging starts and will take approximately 16 hours for
4After 16 hours
5Remove the charger AC plug from the AC wall outlet.
◆Exceeding the specified charge period shortens the useful life of the NiCd battery pack.
◆The provided charger is designed to charge only the provided
2