19
CONVENTIONAL SCAN
If the Scan function is programmed, Conventional zones or
channels can be scanned by pressing the key programmed as
Scan. Scan can be used as either Single Scan or Multi Scan.
•Single Scan monitors only the channels of the currently selected
zone, which have been added to the scanning sequence. If set
up to scan Priority channels, the Priority channels will be scanned
even if they are not within the currently selected zone.
•Multi Scan monitors all channels of every zone, which have been
added to the scanning sequence.
To activate Scan, press the key programmed as Scan.
•The icon and “ ” or the revert zone and channel number
appear on the display.
•The zone add indicator ( ) will appear on the
display when the selected zone is added to the scan sequence.
The channel add indicator ( ) will appear on the
display when the selected channel is added to the scan
sequence.
•When a call is received, scanning stops and the zone and
channel digits appear. Press the PTT switch and speak into the
microphone to respond to the call. The transceiver will continue
scanning after a predetermined time delay if the PTT switch is
released and no further signal is received.
To stop scanning, press the Scan key again.

ADD TO SCAN/ DELETE FROM SCAN

Press the key programmed as Scan Delete/Add to add or
remove each channel to or from the scan sequence.
•The channel add indicator ( ) will appear on the
display when the selected channel is added to the scan
sequence.
Press the key programmed as Zone Delete/Add to add or
remove each zone to or from the scan sequence.
•The zone add indicator ( ) will appear on the
display when the selected zone is added to the scan sequence.