Kenwood TS-480HX, TS-480SAT instruction manual Panel and Microphone Connection

1 INSTALLATION

PANEL AND MICROPHONE CONNECTION

Plug the microphone plug to the MIC jack (8-wire/ RJ45), then connect the Remote Control panel to the TX/ RX unit with the supplied cable (2 m/ 6-wire/ RJ11).

Microphone

To MIC

3cm

EXT.SP	DATA	REMOTE
MIC
PANEL
		COM

P
ADDLE	KEY

To PANEL

Line filter

PANEL AND MICROPHONE CONNECTION USING PG-4Z (OPTION)

Use the cables and connectors to connect the Remote Control panel and TX/ RX unit with the PG-4Z cable kit as shown below.

Extension adaptor (RJ45) from the PG-4Z cable kit

Extension cable (RJ45) from the PG-4Z cable kit

PANEL

EXT.SP DATA

REMOTE

Line filter (large) from the PG-4Z cable kit

Line filter (small) from the TS-480

To MIC

	3	cm
			ADDLE	KEY
3	cm		To EXT.SP

1 cm

EXT.SP DATA REMOTE

P

COM

To external speaker

	External speaker extension
Extension cable (RJ11)	cable from the PG-4Z cable
from the PG-4Z cable kit	kit (when the external speaker
	is used)

Cable holder

Line filter (small) from the PG-4Z cable kit

Tapping screw

(4 mm x 14 mm)

Flat washer

Microphone cable

RJ45 (8-wire) adaptor

Double-sided adhesive tape

Extension adaptor (RJ11)

from the PG-4Z cable kit

6