58
VS-3 VOICE SYNTHESIZER UNIT
CAUTION:
SWITCH OFF THE POWER AND UNPLUG THE DC
POWER CABLE BEFORE BEGINNING INSTALLATION.
1Remove the bottom case (8 screws).
2Hold the VS-3 unit with the component side facing
inward, and insert the VS-3 connector into the
transceiver CN16 connector.
3Replace the bottom case (8 screws).
Note:
The VR8 allows you to adjust the volume for voice
announcement. Use only when the volume level is too low or too
high.
YK-88C-1/ YK-88CN-1/ YK-88SN-1
FILTERS
CAUTION:
SWITCH OFF THE POWER AND UNPLUG THE DC
POWER CABLE BEFORE BEGINNING INSTALLATION.
1Remove the 2 screws from the bottom cover of the
transceiver.
2Remove the bottom cover.
14 INSTALLING OPTIONS
3Remove the 2 screws from the OPTION FILTER
section of the transceiver PC board.
4Align the pins of the transceiver CN8 and CN9
connectors with the two connectors on the filter.
•Take care to properly align the pins.
5While holding the filter, carefully push down until the
filter snaps into place.
6Re-install the 2 screws that you removed in step 3.
7Replace the bottom cover (2 screws).
Note:
After installing the filter, be sure to select the appropriate
setting in Menu No. 46; otherwise the filter will not function.
VR8
Bottom cover
CN9
CN8
Filter
CN16
Component side VS-3