97
Troubleshooting
Sound
The 96k fs indicator does not light while a 96k fs compatible disc is
being played.
• The indicator will not light unless the DVD player is properly set.
• All of the speakers have been activated in the Setup Speakers menu.
See Chapter Two of the Connections and Setup Guide.
• The individual speaker levels are set properly. See Chapter Two of the
Connections and Setup Guide.
• The CD2/TAPE2 MONITOR input has not been selected. (If it has,
the CD2/TAPE2 MONITOR indicator on the receiver’s front panel
will be lit). See “What’s on the Front Panel of Your Kenwood Audio -
Video Receiver?” on page 2 of this manual.
• The correct speakers have been activated. See “Turning the Speakers
On” on page 10 of this manual.
• The correct listen mode has been selected. See “What Are Listen
Modes?” on page 18 of this manual.
I can’t hear sound from my surround or center speakers
Check that:
• The proper surround play mode (Dolby Pro Logic, Dolby Pro Logic
II, DSP, MPEG, DTS, DTS-ES or Dolby Digital) has been selected. See
“What are Listen Modes?” on page 18 of this manual.
• All of the speaker wires are connected tightly. See Chapter One of the
Connections and Setup Guide.
I can hear sound only from the center speaker when Dolby Pro
Logic is selected
Check that the program (e.g., TV show, radio station, VCR tape) is in
stereo. Programs in mono play only through the center speaker when the
receiver is in the Dolby Pro Logic listen mode.
A DT S-ES encoded source is played but it is not decoded in D TS-ES.
Check that:
• DTS-ES decoding in playback is not available if THX Surround EX is
set to On, THX Surround EX Auto or THX is On. Set THX to Off.