103
Troubleshooting
Receiver/Tuner
Receiver/Tuner
My receiver won’t turn on and the STANDBY indicator is flashing
Your receiver is in the “protection” mode.
Check that:
• The speaker system’s impedance is not too low. See Chapter One of
the Connections and Setup Guide.
• The speaker wires are not short-circuited. Test the wires as follows to
find the shorted wire and replace it:
1Turn off the receiver, disconnect the positive and negative speaker
wires of the RIGHT FRONT speaker from the receiver, and turn
the receiver back on.
2If the STANDBY indicator stops flashing, replace this wire.
3If the STANDBY indicator does not stop flashing, turn off the re-
ceiver, reconnect the speaker wires, and repeat the first step for the
next speaker.
4Continue until you have isolated and replaced the shortedwire.
5See Chapter One of the Connections and Setup Guide.
If none of the above solutions work, reset the microprocessor:
1. Turn the receiver off. (The Power button is OFF position.)
2. Press ON/STANDBY button while pressing and holding the Power
button.
The following settings are cleared:
• The device set as input (Tuner is selected by default)—see “How
Do I Operate Devices?” on page 35 of this manual.
• The volume setting (-48dB is selected by default)—see “Adjusting
the Volume” on page 11 of this manual.
• The tuner’s receiving band (FM is selected by default)— see “Tuner”
on page 57 of this manual.
• The tuner’s frequency (87.5MHz is selected by default)— see
“Tuner” on page 57 of this manual
• The tuner’s preset memory—you will need to reset your stored
radio stations (see Chapter Two of the Connections and Setup Guide)