Using PowerTouch
71
How Do I Record (Edit Mode)?
3. Select the recording destination device and touch . PowerTouch
displays the control screen for the destination device.
The (Source) and (Destination) are displayed on the left side
of the control screen.
Each touch of the or switches between the source device con-
trol screen and the destination device control screen.
4. Touch the record control on the destination device, then switch to the
source device and touch the play control.
5. Touch any Quick Access button to change to that menu.
For more information on recording with any connected device, see the
device’s instruction manual.
• If you’re recording from a digital source, any action other than adjust-
ing the volume may cause the sound to “clip” on the recording.
• You cannot record from the component you are using to record. For
example, if you’re recording on a VCR connected to the VIDEO1 jacks,
select a source other than Video 1.
• If your source is a camcorder or other video unit, refer to the instruc-
tion manual for the particular unit you’re recording from.
Digital to Digital Recording:
The PCM digital signal input through any DIGITAL IN jack is output digi-
tally at the digital jack. For more information on this connection, see
“Connecting Your MD Recorder or Primary Tape Deck” on page 20 of
the Connections and Setup Guide.
Dolby Digital and DTS signals cannot be recorded.
Digital to Analog Recording:
While home VCRs can record only two channels of audio, the receiver is
capable of "down-mixing" the multi-channel audio of Dolby Digital, DTS
or MPEG into stereo sound. Down-mixing is available by setting the Digital
Rec mode to “REC MODE: AUTO or “REC MODE: MANUAL”.