* Commercially available parts
■Multi Amplifier with Remote cable connection (Accessory of
CAUTION
• Before connecting the remote controller cables, always turn the Bass boost level knob all the way to the left.
You can control the Bass boost level of the second and subsequent Slave amplifiers simultaneously from the Master amplifier.
The volume level of each amplifier is determined by the setting of the Master amplifier (INPUT SENSITIVITY, boost level of the remote controller).
Setting the Master amplifier
1.Adjust the INPUT SENSIVITY to the output of the center unit to be connected.
2.Set the LPF frequency and ISF.
3.Turn the LINE OUT FILTER switch ON.
Setting the Slave amplifier
1.Turn the LINE OUT FILTER switch OFF.
2.Adjust the INPUT SENSIVITY.
•To adjust the Slave amplifier to the same volume as the Master amplifier, adjust the INPUT SENSIVITY to 0.2 V (max.).
|
|
| Remote cable | ||
CENTER UNIT |
|
| RCA cable* |
|
|
(CD receiver, etc.) |
|
|
|
| |
Power control wire* |
|
|
|
| |
FUSE [30Ax2] | BATT. | GND | REMOTE | IN | LINE OUT |
| |||||
|
|
|
| ||
|
|
|
| L |
|
|
|
|
| R |
|
| P. |
| SPEAKER OUTPUT |
|
|
Master amplifier |
|
|
|
| |
Extension wire* |
|
|
| RCA cable* | |
FUSE [30Ax2] | BATT. | GND | REMOTE | IN | LINE OUT |
|
|
|
| L |
|
|
|
|
| R |
|
| P. |
| SPEAKER OUTPUT |
|
|
Slave amplifier |
|
|
|
| |
Hexagon Wrench |
|
|
|
|
|
(Small) |
|
|
|
|
|
Use the |
| GND |
|
|
|
attached BATT. | REMOTE | IN | LINE OUT | ||
FUSE [30Ax2] |
|
|
| ||
Hexagon |
|
|
| L |
|
Wrench. |
|
|
| R |
|
| P.CON |
| SPEAKER OUTPUT |
|
|
Slave amplifier |
|
|
|
| |
Remote controller
LINE OUT FILTER
OFF ON
2 | 1 | |
0.5 | ||
| ||
3 | 0.3 | |
4 | ||
0.2 | ||
[MIN] 5 |
[MAX]
LINE OUT FILTER
OFF ON
2 | 1 | |
0.5 | ||
| ||
3 | 0.3 | |
4 | ||
[MIN] 5 | 0.2 |
[MAX]
LINE OUT FILTER
OFF ON
2 | 1 | |
0.5 | ||
| ||
3 | 0.3 | |
4 | ||
0.2 | ||
[MIN] 5 |
[MAX]
English