The KODAK KLI-8023 Image Sensor is a multispectral,
linear solid state image sensor for color scanning
applications where ultra-high resolution is required.
The imager consists of three parallel linear photodiode
arrays, each with 8000 active photosites for the output of
R, G, and B signals. This device offers high sensitivity,
high data rates, low noise and negligible lag. Individual
electronic exposure control for each color allows the
KLI-8023 sensor to beused under a variety of illumination
conditions. The imager can be operated in an “Extended
Dynamic Range” mode for the most demanding
applications.
FEATURES • 12 line spacing between color channels
• Single shift register per channel
• High offband spectral rejection
• Dark reference pixels provided
• Antireflective glass
• Wide dynamic range, low noise
• Dual dynamic range mode operation
• No image lag
• Electronic exposure control
• High charge transfer efficiency
• Two-phase register clocking
• 74ACT logic compatible clocks
• 6MHz maximum data rate
APPLICATIONS • Photography
• Medical Imaging
• Scientific Imaging
Parameter Typical Value
Architecture 3 Channel, RGB Trilinear CCD
Pixel Count 8002 x 3
Pixel Size 9 µm (H) x 9 µm (V)
Pixel Pitch 9 µm
Inter-Array Spacing 108µm (12 lines effective)
Imager Size 72.0 mm (H) x 0.225 mm (V)
Saturation Signal 185k electrons (Normal DR mode)
400k electrons (Extended DR mode)
Dynamic Range
(2 MHz Data Rate)
84 dB (Normal DR mode) 90 dB
(Extended DR mode)
Responsivity
(wavelength= 460, 540, 650 nm) 14, 17, 26 V/µJ/cm2
Output Sensitivity 14.4 µV/electron
Dark Current 0.002 pA/pixel
Dark Current Doubling Rate 8° C
Charge Transfer Efficiency 0.999998/Transfer
Photoresponse Non-uniformity 3% Peak-Peak
Lag (First Field) 0.025%
Maximum Data Rate 6 MHz/Channel
Package CERDIP (Sidebrazed, CuW)
Cover Glass AR coated, 2 sides
Parameters above are specified at T = 25°C (junction temperature) and
1 MHz clock rates unless otherwise noted.
www.kodak.com/go/imagers