26
5. Connect the pedal cable and power cable, and
fasten them.
Connect the power cable included with the piano to
the socket located on the back of the piano.
Insert the pedal cable
connector into the pedal
connector located on the
bottom of the piano. Be
sure that the connector is
inserted in the correct
orientation.
Use the cable
holder to fasten
the pedal cable.
Place the piano at a distance from the wall, so that
the power supply cable on the back panel is not
strained.

Check after assembly

[ ]Are any parts left over?
If any parts are left over, check the diagrams to see
where they should be used.
[ ]Make sure that all screws are tight.
Caution
Caution when transporting the instrument
Remove the piano from its stand, and transport them
separately. After transportation, refer to these instruc-
tions and re-assemble the piano and stand.
Loosened screws
After assembly, the various screws of the stand may
loosen after prolonged use, causing the stand to
wobble. If this occurs, re-tighten the screws.
Disassembly
If you need to packup the C-4500, reverse the order by
which the piano was attached to the stand and the
stand was assembled. After disassembly, save the
screws and other parts so that no parts are lost.