Korg music workstation/sampler

pitch change speed, volume, the pan following an insert

effect, pan, volume, or send levels to the master effects

(☞PG p.282).

You can use this as a source for alternate modulation

or effect dynamic modulation, and use it to control

program parameters or effect parameters. In this case,

set “Foot Switch Assign” to Foot SW (CC#82), and

“Foot Pedal Assign” to Foot Pedal (CC#04).

Here we will show how to make settings that allow an

assignable switch to change programs or combinations.

1Press the “Foot Switch Assign” popup button, and

press either Program Up or Program Down.

Program Up will cause the next higher program num-

ber to be selected each time you press the foot switch.

Program Down will cause the next lower program

number to be selected each time you press the foot

switch.

2Set the “Foot Switch Polarity” to the polarity of the

foot switch you have connected.

If you have connected a Korg PS-1 pedal switch, set

this to (–) KORG Standard. If the polarity is not set

correctly, the pedal will not function appropriately.

3Either press the [PROG] key to enter Program P0:

Play, or press the [COMBI] key to enter Combination

P0: Play. When you press the foot switch, the pro-

gram/combination will change.

Creating original scales

P3: User Scale

Creating a scale and assigning it to a

program etc.

You can create your own original scales. You can create

sixteen different User Octave Scales in which the pitch of

each note of the octave is repeated for all octaves, and one

User All Note Scale in which the pitch of each of the 128

notes can be speciﬁed independently.

By adjusting the pitch of each key in the range of ±99, you

can raise or lower it by as much as approximately one

semitone relative to the normal pitch.

The user scales you create here can be used by specifying

the scale for a program, for each timbre of a combination,

or for each track of a song (Sequencer/Song Play).

These settings are made by the Scale “Use Prog’s Scale”

parameters in the following pages.

Here is how to set the scale type for each timbre in

Sequencer mode.

1Create a user octave scale or a user all notes scale.

Select a key, and use the VALUE contr oller to adjust the

pitch. The range of ±99 raises or lowers the pitch

approximately one semitone above or below the stan-

dard pitch.

You can also select a key by holding down the

[ENTER] key and playing the desired note on the

keyboard.

You can copy one of the preset scales and edit it to

create an original scale. Execute the page menu com-

mand “Copy Scale.”

2Press the [SEQ] key to enter Sequencer mode.

3After pressing the [MENU] key, press the P2: Trk

Param.

4Press the Other 1–8 tab or Other 9–16 tab to select the

Sequencer P2: Trk Param, Other page.

5If you wish the program assigned to a track to use the

scale saved with that individual program check the

“Use Program’s Scale” check box for that track.

Tracks that are not checked will use the scale speciﬁed

by Scale “Type (Song’s Scale).”

6Set “Type (Song’s Scale)” to select the scale for the

currently selected song.

Program mode Program P1: Edit-Basic, Program Basic

Combination mode Combination P2: Edit-Trk Param, Other

Sequencer mode Sequencer P2: Trk Param, Other

Song Play mode Song Play P1: Track, Status/Scale

Program

Combination

SequencerSamplingSong PlayGlobalEffectMedia, etcPresetOther