Quick Start Listening to the demo songs
5
Listening to the demo songs in Sequencer
mode
1. Press the MODE SEQ switch (the LED will light)
to enter Sequencer mode.
2. Access the P0: Play/REC– MIDI Track Prog
Select/Mixer page.
If this page is not displayed, press the EXIT switch.
Although the exact number will depend on the page
you’re in, pressing the EXIT switch no more than
three times will take you to the top page of P0.
3. Let’s start by listening to song S000.
Verify that song S000 is selected. If another song is
selected, press the song name display area (“Song
Select”) to highlight it. Then press the numeric key
0, and then the ENTER switch.
4. Press the SEQUENCER START/STOP switch.
The LED will blink, and the song will begin playing
back.
5. If you want to stop playback mid-way through the
song, press the START/STOP switch once again.
6. Let’s listen to the next song.
Press the song name display area (“Song Select”).
Press numeric key 1, and then press the ENTER
switch. (Song “S001” will be selected.)
Alternatively, you can press the round button (Song
Select popup) located at the left of the song name,
and a list of song names will appear. Select a song,
and press the OK button.
7. Press the SEQUENCER START/STOP switch to
begin playback. To stop playback, press the same
switch once again.
This completes our quick start.
Of the OASYS’ wide range of functionality, this
operation guide explains how to use some of the most
typical operations. We highly recommend that you
take the time to read it completely.
When you’ve finished working with the OASYS, press
the rear panel POWER switch to turn off the power.
When you turn off the power, the programs and
combinations etc. will revert to the state in which
they were before you edited them. If you want to
keep your edited settings, you’ll need to Write
them. For more information, see “Saving your
edits” on page 54.
Similarly, the songs and demo songs, as well as the
user multisamples and samples used by these
songs, will disappear when you turn off the power.
If you want to use these songs, user multisamples,
and samples the next time you turn on the power,
you’ll need to load them again.
Popup Song Select