SIMPLE OPERATING INSTRUCTIONS

 

 

Pellet

 

ADVANTAGE OPTIMA AND PROFILE SERIES

 

 

 

Models:

 

TRADITIONS T300P-2SERIES

 

 

 

 

Stove

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1. Start

 

 

 

OPERATING SIMPLE

2. Preparation

a] Check hopper and remove any materials from hopper and auger.

b] Preset damper

Note: Damper is preset at factory for all models except Optima 3 INS and Profile 30 INS-2 (for these models set damper at 1/2 open). For model T300P ensure that damper has not moved from it's factory setting of 3 notches out.

c] Visually check venting and termination for leakage.

d] Check UltraGrateTM for proper fit (ensure grate is

set securely in the base).

e] Check door switch for alignment and contact.

Note: Profile 30(-2) models only.

f] Check door gasket and door latch to ensure tight seal.

g] Check ash pan and door for proper seal. Confirm ash slides are closed securely (Profile and T300P models only).

h] Connect power cord to grounded power supply outlet.

3. Priming the Auger

a] Fill hopper with pellets

Note: use quality grade pellet fuel.

b] Push the on/off button to turn on the auger motor.

c] After 2 minutes push the on/off button. Wait 5 minutes and push the on/off button to start.

d] When pellets begin to drop from feed tube into UltraGrateTM, push the on/off button to stop the auger.

4.Stove is now ready for start-up.

5. To Start Your Stove

a] Push the on/off button

Note: Room air blower and exhaust blower will run at start up settings.

6.Flame should appear in stove within approx. 8 minutes.

Does the Stove Light?

YES

7.Set stove to desired heat setting (heat select button).

8.After approx. 5 minutes adjust damper if necessary to obtain a bright vibrant flame.

Notes: If the damper is too far closed, the flame will be lazy/sooty and the fuel will pile up in the UltraGrateTM.

If the damper is too far open, the flame might be extinguished due to too much combustion air.

9.To Turn Off Pellet Stove (Manual Operation Only)

a] Push on/off button, stove enters shut down mode.

b] Pellets stop feeding and the fire dies down. Approx. one min. later the room air blower and exhaust blower change to cool down setting. Approx. 15 minutes after shut

down cycle begins, stove shuts off.

NO

7a. Follow the troubleshooting section of the Homeowner's "Installation and Operation" Manual.

Does the Stove Light?

NO

Contact your

Lennox Hearth Products

Dealer for further assistance.

INSTRUCTIONS

PLACE DEALER LABEL HERE

60020191 Rev. C

Refer to "Installation

and Operation" manual for further instructions in adjusting damper using thermostat

vs. manual modes.

10.Thank you for purchasing a Whitfield or Traditions by

Lennox Pellet Stove.

END

45