1
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
BLOWER KITS
COUNTRY COLLECTION™ WOODSTOVES
P/N 506033-34
Rev. NC, 11/2009
HEARTH PRODUCTS
KITS AND ACCESSORIES
KIT CONTENTS
1 ea. Blower Assembly (item #1)
1 ea. Snap Switch and Control Panel Housings (item #2)
1 ea. Instruction Sheet
TOOLS NEEDED
5/32 Allen Wrench Or T Handle Wrench
9/16” Socket Wrench
9/16” Open End Wrench
Large Flat Head Screwdriver
FPO
INSTALLATION INSTRUCTIONS FOR INSTALLING BLOWER
KITS FOR USE WITh COUNTRY COLLECTION™ MODELS S160, SA160, SS210,
ST210, S260 AND ST310 FREESTANDING WOODSTOVES

WARNINGS

The blower must be plugged directly into a properly
grounded three-prong receptacle, 120 VAC, 60 hz, single
phase. Do not cut or remove the grounding prong from
this plug. Do not route power cord under or in front of
appliance.
Installation must be in accordance with National Elec-
trical Code, ANSI/NFPA 70 - latest edition. In Canada,
the current CSA C22-1 Canadian Electrical Code - latest
edition.
DANGER: Disconnect power before servicing blower.
In the event that you remove the blower for any reason,
make sure a cover plate (available from Lennox hearth
Products) is installed before using the heater. Excessive
rear wall temperatures will result if the stove is burned
without the cover plate. The cover plate is not necessary
if a blower has never been installed because a knock-out
will be in place to act as the cover.
ThERMALLY ACTIVATED BLOWER KIT
Cat. No. Model Description
h7917 BLWR-FSB700-SS Blower Kit, FS Woodstoves
Figure 1 - Kit Contents
GENERAL INFORMATION
This optional blower kit can be installed to improve hot air distribution
throughout the room.
The 700-CFM room air circulation blower kit comes
with a variable speed control (rheostat) and an snap switch which will
provide automatic thermal activation of the blower, when desired (see
Blower Operation on Page 6).
If you encounter any problems, need clarification of these instructions or
are not qualified to properly install this kit, contact your local distributor
or dealer.
Read this instruction sheet in its entirety before beginning the installa-
tion.
ALL WARNINGS AND PRECAUTIONS IN ThE INSTALLATION AND
OPERATION MANUAL PROVIDED WITh ThE APPLIANCE APPLY TO
ThESE INSTRUCTIONS.
ShUT DOWN ThE STOVE AND ALLOW IT TO COMPLETELY COOL BEFORE
PROCEEDING.
1
2