GRANDVIEW™ LEG KITS

INSTALLATION INSTRUCTIONS FOR INSTALLING LEGS ON A GRANDVIEW™ 230 WOODSTOVE
P/N 506033-52
Rev. NC, 08/2011
HEARTH PRODUCTSKITS AND ACCESSORIES

KIT CONTENTS

Please ensure that all these parts are included
4 ea. Legs
4 ea. Hex Bolts 3/8” x 1” Length
4 ea. Washers 3/8”
Grandview™ Leg Kits
Cat. No. Model Description
H8339 LEG-COSTL-BLK Coastal Legs, Black
H8340 LEG-COSTL-BRNKL Coastal Legs, Brushed Nickel
H8341 LEG-COSTL-NKL Coastal Legs, Nickel
H8342 LEG-LKVIEW-BLK Lakeview Legs, Black
70000 LEG-OLY-B Olympic Sculptured Black
70002 LEG-OLY-N Olympic Sculptured Nickel
70008 LEG-OLY-BRN Olympic Sculptured Brushed Nickel
1

TOOLS NEEDED

9/16” Open End Wrench Or Socket

GENERAL INFORMATION

If you encounter any problems, need clarification of these instructions or
are not qualified to properly install this kit, contact you local distributor
or dealer.
Read this instruction sheet in its entirety before beginning the installation.
ALL WARNINGS, PRECAUTIONS AND INSTRUCTIONS IN THE INSTAL-
LATION AND OPERATION MANUAL PROVIDED WITH THE APPLIANCE
APPLY TO THESE INSTRUCTIONS.
Check the contents of the kits upon receipt and check for any damaged
or missing parts. If there is hidden damage, notify your freight company
or Lennox Hearth Products dealer immediately.

CAUTION: Wear gloves during installation in case of sharp

edges on the stove.

Be sure to clean plated surfaces with a soft cloth and household glass
cleaner prior to burning the appliance. Fingerprints left on plated
surfaces while burning may remain on the finish permanently.

INSTALLATION INSTRUCTIONS

Step 1. Carefully place stove on it’s back. Be careful not to scratch the
stove,use a piece of cardboard or carpet to protect the back of the
stove.
Step 2. Using a 9/16” wrench or socket remove the bolt in each of the four
corners along with the attached shipping brackets.
Step 3. Remove legs from the packaging and using the bolts and washers
that come with the legs install each leg in each corner with one bolt
and one washer.
Step 4. Before the legs are fully tightened down make sure that they are
aligned correctly to match the front and side planes of the stove.
Step 5. The stove can now be set up on the legs making sure that all baffle
boards and bricks are set back in place. These items may have
shifted when the stove was placed on it’s back.
Step 6. If it is necessary to level, secure, or ground your stove, use the
holes in the bottom of the leg for those applications. To level the
stove use leg leveling kit (P/N H8407) or leveling pads (P/N H7638).
Level by adjusting the bolt or leveling pad down on each leg that is
not in full contact with the hearth or surface below that the stove
in located on.

Figure 1

NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.
Printed in U.S.A. © 2011 Lennox Hearth Products
P/N 506033-52 Rev. NC 08/2011
Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products.
Consult your local distributor for fireplace code information.
Lennox Hearth Products
1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210