Figure 4

step 5. Using a phillips screwdriver (through upper grill opening) attach
the screen face to the fireplace starting with the upper brackets.
Screw the upper brackets in part way only, you will tighten them
in step 7.
step 6. Open the lower door on the screen face and thread the two 1/4”-20
phillips head screws (provided) through the lower hinge mounts
into the speed nuts on lower face brackets, attached to the fireplace
(see Figure 4).
step 7. Adjust the alignment and depth of the screen face until it sits flush
with the wall and tighten all four mounting screws. DO nOt OVer-
tiGhten the screws.
step 8. Finish the installation by putting the screen doors back on their
hinges (check to make sure the washers are in place).
nOte: DiaGraMs & iLLUstratiOns are nOt tO scaLe
step 2. Using a 5/32” allen wrench, remove the lower face brackets on
the fireplace and replace with the lower brackets (C) using the
four 10-24 allen head screws provided (see Figures 3 and 4). DO
nOt OVertiGhten the screws.
step 3. Using a 3/8” socket or nut driver, attach the two upper mounting
brackets (B in Figure 3) to the six pre-welded studs near the top
rear of the screen face, using the six #10 washers and #10 hex nuts
provided (see Figures 3 and 4). DO nOt OVertiGhten nUts.
this side of
brackets mount
to fireplace (see
Figure 4)
(B) Upper face Brackets
(c) Lower face Bracket
10-24 allen
head screws
speed nut
#10 washers
and nuts
1/4”-20 Phillips
head screws
screw through the
lower hinge mounts
into the speed
nuts on lower face
brackets

Figure 5 - Completed Installation

Printed in U.s.a. © 2008 Lennox hearth Products
P/n 775,289M reV. a 10/2008
Lennox reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local
distributor for fireplace code information.
Lennox hearth Products
1110 west taft avenue • Orange, ca 92865
step 4. Remove the screen doors from the face by gently lifting up and
out of their hinges. Check to make sure the washers that separate
the two halves of the hinge have not fallen off. Set the screen door
aside.
2

Figure 3

u
u a 1/4” screw
with push nut will be
installed on upper
mounting brackets (not
shown). the push nut
holds the screw in place
when installing face.