4059-XXX
Double Feeding Paper
Note: If double feeding paper occurs mostly from the bottom of the stack, check for missing or damaged restraint pads in the tray.
| FRU | Action |
|
|
|
1 | Paper | Paper is usually the primary cause of |
|
| a double feeding paper problem. |
|
| Flex the paper before placing the |
|
| paper in the tray. Edge welded paper |
|
| is the most common cause of double |
|
| feeding. Loading the paper in the |
|
| tray in different locations and |
|
| directions and using rough paper |
|
| and short grain paper also causes |
|
| double feeding. |
|
|
|
2 | Autocompensator | Make sure the counterbalance |
|
| spring is not missing, loose or |
|
| broken at the top of the |
|
| autocompensator arm assembly. If |
|
| you find a problem, replace the |
|
| autocompensator assembly. |
|
|
|
Multipurpose Tray
Paper fails to feed from the multipurpose tray.
The pick roll should make one complete revolution and stop with the flat side down. If the pick roll turns but does not pick paper, check the roll for signs of wear, oil or grease on the surface of the pick roll or slick spots. If you find a problem, replace the pick roll assembly. Check to ensure the media that is being fed through the multipurpose tray assembly meets recommended paper specifications.
