4059-XXX
| FRU | Action |
|
|
|
5 | High Capacity Feeder | Check the voltage on |
| Option Control Board | The voltage measures +24 V dc. If |
|
| incorrect, check the autoconnect |
|
| system for any problems. +24 V dc |
|
| must come from the base printer |
|
| through the autoconnect system to |
|
| the high capacity input for the high |
|
| capacity feeder to be recognized. If |
|
| the voltage is correct, check the |
|
| voltages at |
|
| 4(red). The voltages measure +24 V |
|
| dc. If correct, replace the high |
|
| capacity feeder option system board. |
|
| If incorrect, disconnect J8 from the |
|
| system board and measure the |
|
| voltages again. If incorrect, check |
|
| the LVPS cable and the A.C. internal |
|
| wiring from the input appliance |
|
| receptacle. If incorrect, replace as |
|
| necessary. If correct, replace the |
|
| LVPS. If the voltages are correct, |
|
| check the stepper motor for shorts |
|
| from the motor housing to each pin |
|
| on the motor connector. If you find a |
|
| short between any pin and the motor |
|
| housing, replace the motor |
|
| assembly. If no shorts are found, |
|
| replace the high capacity feeder |
|
| option control board. |
|
| Check the voltage at |
|
| blue). The voltage measures |
|
| approximately +24 V dc. If incorrect, |
|
| disconnect the cable at J9 and check |
|
| the voltage again. If the voltage |
|
| continues to be incorrect, replace |
|
| the high capacity feeder option |
|
| system board. If the voltage |
|
| measures correctly, check the cable. |
|
| If the cable is damaged, replace as |
|
| necessary. If no problem is found |
|
| with the cable, replace the high |
|
| capacity feeder option control board. |
|
|
|